Dell OptiPlex Small Form Factor 7010 Owner's Manual page 45
Hide thumbs
Also See for OptiPlex Small Form Factor 7010:
- Owner's manual (119 pages) ,
- Owner's manual (119 pages) ,
- Owner's manual (119 pages)
Table of Contents
Advertisement
Steps
1. Disconnect the data and power cables from the hard drive.
2. Remove the two screws (6-32) that secure the hard-drive carrier to the chassis.
3. Slide the hard-drive carrier away from the chassis and lift hard-drive carrier out of the disk-drive cage.
4. Remove the two screws (6-32) that secure the hard drive to the hard-drive carrier.
5. Slide and remove the hard drive from the hard-drive carrier.
Installing the 3.5-inch hard drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 3.5-inch hard drive and provide a visual representation of the installation
procedure.
Rimozione e installazione delle unità sostituibili dal cliente (CRU)
45
Advertisement
Table of Contents
