Replacing The Motor Protection Filter; Replacing The Airclean Exhaust Filter; Replacing The Active Airclean 30/Hepa Airclean 30 Exhaust Filter; Insert The Hose Connector Into The Suction Opening On The Vacuum Cleaner Until It Clicks Into Position - Miele Classic C1 Flex Operating Instructions Manual

 Fit the new dustbag into the holder
as far as it will go. Leave the dustbag
folded up when you take it out of the
box.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
A safety device prevents the lid clos-
ing without a dustbag in place. Do not
force it.
 Insert the hose connector into the
suction opening on the vacuum
cleaner until it clicks into position.

Replacing the motor protection filter

(Fig. 25)
Replace the motor protection filter
whenever you start a new packet of
dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain 4 motor protection fil-
ters.
 Open the dust compartment lid.
 Pull the dustbag out by the grip on
the collar.
 Unclip the filter frame and replace the
motor protection filter.
 Close the filter frame.
 Fit the dustbag into the holder as far
as it will go.
 Close the dust compartment lid.

Replacing the AirClean exhaust filter

(Fig. 26)
Do not use more than one exhaust
filter at a time.
Replace this exhaust filter every time
you start a new packet of Miele dust-
bags. Every packet of original Miele
dustbags contains one AirClean ex-
haust filter. Multipacks contain 4
AirClean exhaust filters.
 Open the dust compartment lid.
 Release the filter grille and raise it
upwards. Grasp the used AirClean
exhaust filter by the clean, unsoiled
section (see arrow) and take it out.
 Replace it with a new AirClean ex-
haust filter.
If you wish to fit an Active AirClean 30
or HEPA AirClean 30 exhaust filter, see
"Replacing one type of exhaust filter
with another".
 Close the filter grille.
 Close the dust compartment lid.
Replacing the Active AirClean 30/
HEPA AirClean 30 exhaust filter
(Fig. 27)
Do not use more than one exhaust
filter at a time.
Replace these exhaust filters if the
timestrip® filter change indicator is
completely red (Fig. 12).
The display will be completely filled with
red after approximately 50 operating
hours; this corresponds to approxim-
ately one year of average use. You can
continue vacuuming when the light
en
43