Mounting The Bar And Chain - Stihl MS 192 T Instruction Manual

English

Mounting the Bar and Chain

Releasing the chain brake
4
Pull the hand guard (4) toward the
N
control handle until there is an
audibleclick – the chain is
disengaged.
Removing the chain sprocket cover
6
5
Unscrew the nut (5) and remove the
N
cover (6).
12
Mounting the guide bar
7
8
Turn the screw (7)
N
counterclockwise until the tensioner
slide (8) butts against left end of
housing slot.
9
10
Fit the guide bar over the stud (9)
N
and engage the peg of the tensioner
slide in the locating hole (10).
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
11
Fit chain around the sprocket (11)
N
and over the guide bar – cutting
edges on top of bar must point to
bar nose.
7
Turn the tensioning screw (7)
N
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
engaged in the bar groove.
MS 192 T, MS 192 TC