System Requirements - SMC Networks SMC2671W Quick Installation Manual

System Requirements

• A web browser, such as Microsoft Internet Explorer 5.5 or above
installed on one PC at your site for configuring the Wireless
Ethernet Adapter.
• CD-ROM drive.
• An AC power outlet.
• Wired or Wireless Network Adapter.
• An available RJ-45 (UTP) port on an Ethernet hub or switch.
• TCP/IP network protocol installed on each PC that needs to
access the Internet.
3
Hardware
The EZ Connect TM 11Mbps Wireless Ethernet Adapter supports 1, 2,
5.5 and 11 Mbps half-duplex connections to Ethernet networks.
This device is fully compliant with 2.4 GHz DSSS CSMA/CA wireless
networking as defined in IEEE 802.11b. It can be connected via an
RJ-45 connection to devices such as Nintendo GameCube, Microsoft
Xbox, Sony PlayStation II, and Ethernet ready embedded devices.
It can also function as an IEEE 802.11b Access Point or as a
Range Extender.
The EZ Connect TM 11Mbps Wireless Ethernet Adapter has three types
of LED indicators. Please check the picture: the front view of the
Adapter and the table below, which displays the current state the
specific LED signifies.
LED Status
Power On (Red)
(PWR) Off
Wireless Blinking (Green)
LAN
(TX/RX)
LAN Blinking (Green)
(LINK/ACT)
On (Green)
Off (Orange)
Function
Power on.
No Power.
Wireless LAN
connection is
transmitting or
receiving.
Blinking: Wired LAN
connection is
transmitting or
receiving.
On (Green): Device
is connected at
100Mbps.
Off (Orange): Device
is connected at
10Mbps active.
4