Samsung WA85GWG User Manual page 19

3. Connect adaptor to the water tap by tightening the screws
fi rmly. Then, turn part(b) following the arrow and put (a) and
(b) together.
4. Connect the water supply hose to the adaptor. Pull down
the part (c) of the water supply hose. When the part (c)
is released, the hose is automatically connected to the
adaptor making a 'click' sound.
If water leaks from the hose after completing the connection, repeat the same steps again.
Use the most conventional type of faucet for the water supply. If the faucet is square or too
big, remove the spacing ring before inserting the faucet into the adaptor.
5. Connect the other end of the water supply hose to the inlet water
valve at the back of the washer. Screw the hose clockwise all the
way in.
5-1. Connect the other end of the water supply hose to the inlet water
valve at the top of the washer. Screw the hose clockwise all the way
in.
• If the water tap is a screw type, assemble a water supply hose that
fi ts to the tap as shown. After completing connection, if water leaks
from the hose, then repeat the same steps.
WA85GWWIP-03222A-03_EN.indd Sec3:19 WA85GWWIP-03222A-03_EN.indd Sec3:19
a
b
c
setting up your washer _19 setting up your washer _19
2013-01-29 2013-01-29 2:42:37 2:42:37