Philips NORELCO 7700 Series Manual page 32

ENGLISH
32
C
C
C
7 The battery symbol slowly blinks to
indicate shaver is charging.
8 Press the ON/OFF button (
SmartClean System to start the cleaning
cycle.
The cleaning symbol will blink.
◗ The cleaning cycle takes approximately 10
minutes.
◗ Do not press the ON/OFF button while the
cleaning cycle is running. If this does occur, the
cleaning cycle will stop and the cleaning symbol
stops blinking. The cleaning cycle can
be re-started by pressing the ON/OFF button
once.
◗ If the power plug is disconnected before the
cleaning cycle is complete, reconnect the plug
into the outlet and the cleaning cycle can be
re-started by pressing the ON/OFF button
once.
NOTE: When the cleaning cartridge filter is full,
the replacement symbol blinks orange. (See
'Replacing the SmartClean System Cartridge').
When the cleaning cycle is complete and
9
the shaver is hygienically clean, the ready
symbol lights up continuously.
The battery symbol on the shaver will light up to
indicate the shaver is fully charged.
) on the