Summary of Contents for Olivetti FS1
- Page 1 Floor Stand FS1 Assembly quick guide Floor Stand Doc Code: DOC0252 August 2020 PUBLICATION ISSUED BY: Olivetti S.p.A. Telecom Italia Group Via Monte Navale 2/C - 10015 Ivrea (TO) Copyright © 2020 Olivetti All rights reserved...
- Page 2 ASSEMBLY OF FS1 FLOOR STAND FOR OLIVETTI FL X1 MAIN FEATURES AND REGULATIONS The floor stand for Olivetti FL X1 termoscanner allows a height regulation between 150cm and 170cm and a 11° tilt regulation. Optionally it can be fixed to the floor through the two holes in the base...
-
Page 3: Packaging Content
PACKAGING CONTENT Screw and washer for the height regulation Base Adjustable rod Cable cover plate Cable cover Tilt adjustment bracket FL X1 Manuale Utente... - Page 4 n ° 2 M8x30 countersunk head n ° 2 M8x20 rounded head n ° 6 M4x12 rounded head screws with hexagon socket screws with hexagon socket screws with cross insert n ° 1 adhesive male / female n ° 4 adhesive felt for floor velcro for fixing termoscanner support power supply...
- Page 5 ASSEMBLY INSTRUCTIONS fix the base to the adjustable rod using the n ° 2 M8x30 countersunk head screws with hexagon socket 2. screw the screw and washer for the height regulation to the adjustable rod at the desired height FL X1 Manuale Utente...
- Page 6 FL X1 (the wall mount bracket is in the termoscanner packaging, not in the stand packaging) using n ° 4 M4x12 rounded head screws with cross insert Wall mount bracket for Olivetti FL X1 termoscanner (included in termoscanner box) Assemble the parts taking care that the cable cover opening will be correctly aligned with the small screw holes in the wall mount bracket according the below image.
- Page 7 5. pass carefully the termoscanner cables in the opening as shown in the below picture 6. fix the termoscanner using the two Allen screws included with the termoscanner block the termoscanner tilt tightly by the screws FL X1 Manuale Utente...
- Page 8 8. plug the power supply cable to the termoscanner and place the cables inside the cable cover, using the cable cover plate and n ° 2 M4x12 rounded head screws with cross insert to close the box 9. optionally it is possible to fix the power supply to the adjustable rod using the n ° 1 adhesive male / female velcro for fixing termoscanner power supply.