Sharp ELSI MATE EL-320W - Electronic Calculator Manual

Also See for ELSI MATE EL-320W:

Operation manual (2 pages)

Operation manual (2 pages)

Operation manual (2 pages)

Table of Contents

Contents

1 BEFORE USE
2 SPECIFICATIONS
3 OPERATIONS
4 TILT DISPLAY
5 BATTERY REPLACEMENT
6 Documents / Resources
- 6.1 Download manual

Sharp ELSI MATE EL-320W - Electronic Calculator Manual

BEFORE USE

Do not press too hard against the LCD panelbecause it contains glass.
Never dispose of the battery in a fire.
Keep battery out of reach of children.
Since this product is not waterproof, do not use it or store it where fluids, for example water, can splash onto it. Raindrops, water spray, juice, coffee, steam, perspiration, etc. will also cause malfunction.
Please press if you see no indication.
This product, including accessories, may changedue to upgrading without prior notice.

SPECIFICATIONS

Type:	Electronic calculator
Operating capacity:	12 digits
Power supply:	Built-in solar cell and Lithium battery (3.0V (DC) CR2032 × 1)
Operating time: (varies according to use and other factors)	Approx. 5 years (with 1 hour of daily use, using the lithium battery only)
Automatic Power-off:	Approx. 7 min.
Operating temperature:	0°C - 40°C (32°F-104°F)
Dimensions:	98mm(W) × 154 mm(D) × 12mm(H) 3-27/32"(W) × 6-1/16"(D) × 15/32"(H)
Weight: (battery included)	Approx. 117 g (0.26 lb.)
Accessories:	Lithium battery (installed), Operation manual

SHARP will not be liable nor responsible for any incidental or consequential economic or property damage caused by misuse and/or malfunctions of this product and its peripherals, unless such liability is acknowledged by law.

OPERATIONS

Press twice to clear any residual values and calculation instructions in the calculator.
Before starting memory calculations, press twice to clear the memory contents.
For expressing calculation examples, only the symbols that are required for explanation are mentioned.
Example procedures are listed in following manner unless otherwise specified.

CONFIGURING THE DECIMAL PLACE
Decimal place setting key:
First, press twice. Then, press and hold and together (about a second) to rotate and select out of three decimal configuration settings. (This is indicated as " + " hereafter.) "F" setting: Decimal place is set to "floating", and will not be fixed. Fractions will be rounded off. "2" or "0" setting: Decimal place is fixed to either "2" or "0". If "2" is selected, fractions are rounded off to two decimal places. Selecting "0" rounds off the decimal part completely.
CONFIGURING THE DECIMAL PLACE

CALCULATING TAX

To perform a tax calculation, first it is absolutely necessary to set and check the tax rate. (The initial tax rate is 0.)
A tax rate can be set (or changed) with a number containing up to four digits. (Decimal point is not regarded as a digit.) The set tax rate is retained until it is changed. However, the set tax rate may be changed or lost if the battery is consumed largely.

(1) • Confirming the tax rate. (0%)

(1) • Set a 5% tax rate.
Calculate the tax on $800 and calculate the total Including tax.

(1) • Perform two calculations using $84 and $52.5, both of which already include tax. (tax rate: 5%)
Calculate the tax on the total and the total without tax.