Protecting The Screen; Assembly - Sony Xperia Z3+ User Manual

1. Charging light/Notification light
2. Front camera lens
3. Ear speaker
4. Proximity/Light sensor
5. Power key
6. Volume/Zoom key
7. Camera key
8. Speaker
9. Charger/USB cable port
Your device supports headsets with a standard 3.5mm 3-pin or 5-pin headphone plug. The
headset jack also supports 4-pin plugs as long as the headphone plug uses the CTIA
standard.

Protecting the screen

At purchase, there are two sheets of plastic film on the front of your device. You can
peel off the outer sheet of film when you start using the device. It is not
recommended to peel off the second sheet of film as it protects your screen from
damage and scratching.

Assembly

Your device only supports nano SIM cards. The nano SIM card and the memory card share the
same holder but have separate slots in the holder. Make sure you don't confuse the two.
To prevent data loss, make sure you turn off your device or unmount the memory card before
you drag out the holder to remove the nano SIM card or memory card from the device.
To insert the nano SIM card
If you insert the nano SIM card while the device is powered on, the device restarts
automatically. The nano SIM card and the memory card share the same holder. If a memory
card is already inserted in the holder and the device is powered on, you must turn off the
device or unmount the memory card before removing the holder to insert the nano SIM card.
You can unmount the memory card under Settings by tapping Storage > Unmount SD card.
This is an Internet version of this publication. © Print only for private use.
10. Strap hole
11. Main Wi-Fi/Bluetooth antenna area
12. Main camera lens
13. Camera light
14. GPS antenna area
15. Headset jack*
16. Second Wi-Fi antenna area
17. Nano SIM/Memory card slot cover
18. NFC™ detection area
8