Appendix E: System Ecp Commands - Roku HD1000 Manual

Appendix E: System ECP Commands

The table below listen commands that affect the HD1000 as a whole. From the shell, the syntax
to invoke these commands is:
ecp system <command> [<arguments>]
The command is not case-sensitive.
Table E1: Commands for the system
POWER "ON" , "STANDBY" or
"QUERY"
VIDEOMODE A valid combination
of one of
[composite, svideo,
component, rgb] and
[480i, 480p, 720p,
768p, 1080i]
SENDKEY Any of: MENU,
POWER, EXIT, NORTH,
SOUTH, EAST, WEST,
SELECT, PREVIOUS,
NEXT, PLAYPAUSE,
ROTATE, INFO,
ZOOM_IN, ZOOM_OUT
VERSION <none>
Sets the power-on state
of the system.
of "On" turns the system
on. "Standby" puts
the system into standby
mode. "Query" returns
whether the unit is on or
in standby. If the unit
is already in the state
requested, the command
will have no effect.
If the pair of settings
(connector and output
mode) is valid, sets
the output to that
mode, otherwise returns
an error. "RESET" is a
special case that sets the
unit into initial video
settings mode.
Simulates a remote
control keypress of the
corresponding button.
Prints out the firmware
version
Roku External Control Protocol for the HD1000
© 2003 Roku, LLC
A argument
16