Whirlpool ENXTL 19 FL Series Operating Instructions Manual page 9

b/c) In both these cases the freezer will maintain a temperature
of about 0°C so that the food does not re-freeze. To turn
off the acoustic signal open and close the refrigerator
door. To restore normal operation bring the FREEZER
OPERATION knob setting to
appliance on again.
The green POWER indicator light flashes.
The appliance is not operating correctly. Contact the Technical
Assistance Centre.
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The OPERATION knobs are not on the correct setting (see
Description).
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The REFRIGERATOR OPERATION knob is not on the correct
setting (see Description).
• The food is in contact with the back inside wall of the
refrigerator.
The motor runs continuously.
• The QUCIK FREEZE button has been pressed (rapid freezing): the
yellow QUCIK FREEZE light is on or flashing (see Description).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
• The thickness of the frost exceeds 2-3 mm (see Maintenance)
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface (see
Installation).
• The appliance has been installed between cabinets that
vibrate and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
The back wall of the refrigerator unit is covered in frost or
droplets of water
• This shows the appliance is operating normally.
(off) and turn the
.
GB
9