Preferred 15.2+ seer2 2-stage packaged hybrid heat dual fuel system with puron (r-410a) refrigerant single and three phase 2-5 nominal tons (sizes 24-60)
Preferred 15 seer 2-stage packaged hybrid heat dual fuel system with puron (r-410a) refrigerant single and three phase 2-5 nominal tons (sizes 24-60) (10 pages)
15 seer 2--stage packaged hybrid heat dual fuel system with puronr (r--410a) refrigerant single and three phase 2--5 nominal tons (sizes 24--60) (68 pages)
Page 1
2-5 Nominal Tons (Sizes 24-60) Owners’ Information Manual A09033 Fig. 1 – Unit 677E NOTE TO EQUIPMENT OWNER: For your convience, please record the model and serial numbers of your new equipment in the spaces provided. This information, along with the installation data and dealer contact information, will be helpful should your system require maintenance or service.
Page 2
677E: Owners’ Information Manual Safety Considerations WARNING Improper installation, adjustment, alteration, service maintenance, or use can cause explosion, fire, electrical shock, or other conditions which FIRE, EXPLOSION, ELECTRICAL SHOCK HAZARD may cause death, personal injury, or property damage. Consult a...
677E: Owners’ Information Manual WARNING FIRE, EXPLOSION, ELECTRICAL SHOCK HAZARD Failure to follow this warning could result in personal injury, death and/or property damage. Do not turn off the electrical power to unit without first turning off the gas supply.
677E: Owners’ Information Manual 3. Turn off the electrical power supply to the unit. NOTE: If the unit is being shut down because of a malfunction, call your dealer as soon as possible. Operating Your Unit The operation of your unit is controlled by the indoor temperature control (thermostat).
677E: Owners’ Information Manual Emergency Heat Mode The other typical application is an accessory filter rack installed inside the unit itself. The following information is given to assist in changing If you should have problems with the heat pump portion of your system, filters used in these internal filter racks.
677E: Owners’ Information Manual Refrigerant Circuit The fan must be kept free of all obstructions to ensure proper cooling. Contact your dealer for any required service. The refrigerant circuit is difficult to check for leaks without the proper Electrical Controls and Wiring equipment.
Page 7
677E: Owners’ Information Manual A13165 Fig. 4 – To Start Unit Gas Heat Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
Page 8
677E: Owners’ Information Manual A13166 Fig. 5 – To Start Unit Electric Cooling MAIN STEP 2 STEP 4 & 5 STEP 1 STEP 3 A09194 Fig. 6 – To Shut-off Unit Gas Heat Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
677E: Owners’ Information Manual MAIN STEP 1 STEP 2 STEP 3 A07797 Fig. 7 – To Shut-off Unit Electric Cooling Combustion Area and Vent System 7. Inspection of all supply-air and return-air ducts for leaks, obstructions, and insulation integrity. Any problems found should For proper and safe operation, the unit needs air for combustion and be resolved at this time.
677E: Owners’ Information Manual ) Check to be sure that your thermostat temperature selector is set dealer knows exactly which unit you have, he may be able to offer below the indoor temperature during the cooling season or above the suggestions over the phone, or save valuable time through indoor temperature during heating season.