Alcatel I211 Quick Start Manual page 22

During SAR testing, this is set to transmit at its highest certified power level in all tested frequency bands, and placed in positions that
simulate RF exposure in usage near the body with the separation of 0 mm. Although the SAR is determined at the highest certified
power level, the actual SAR level of the device while operating can be well below the maximum value. This is because the device is
designed to operate at multiple power levels so as to use only the power required to reach the network. In general, the closer you
are to a wireless base station antenna, the lower the power output.
The exposure standard for wireless s employs a unit of measurement known as the Specific Absorption Rate, or SAR. The SAR limit
set by the FCC is 1.6W/kg.
Tests for SAR are conducted using standard operating positions accepted by the FCC with the device transmitting at its highest
certified power level in all tested frequency bands.
The FCC has granted an Equipment Authorization for this model device with all reported SAR levels evaluated as in compliance with
the FCC RF exposure guidelines. SAR information on this model device is on file with the FCC and can be found under the Display
Grant section of HYPERLINK "http://www.fcc.gov/oet/ea/fccid" www.fcc.gov/oet/ea/fccid after searching on:
ONETOUCH PIXI 7 I211 FCC ID: RAD469
For this device, the highest reported SAR value for usage near the body is:
ONE TOUCH PIXI 7 I211 (Body-worn)
SAR compliance for body operation is based on a separation distance of 0 mm between the device and the human body. During use,
the actual SAR values for this device are usually well below the values stated above. This is because, for purposes of system efficiency
and to minimize interference on the network, the operating power of your device is automatically decreased when full power is not
needed. The lower the power output of the device, the lower its SAR value.
Body-worn SAR testing has been carried out at a separation distance of 0 mm. To meet RF exposure guidelines during body-worn
operation, the device should be positioned at least this distance away from the body.
If you are not using an approved accessory ensure that whatever product is used is free of any metal and that it positions the device
the indicated distance away from the body.
IP4899_I211_QG_Eng_USA_01_140505.indd 22 IP4899_I211_QG_Eng_USA_01_140505.indd 22
Maximum SAR for this model and conditions under which it was recorded:
22
0.66 W/kg
2014-5-5 下午 1:09:31 2014-5-5 下午 1:09:31