Scheduling And Reviewing Cleans; Looking After Your Robot - Dyson 360 Vis Nav User Manual

Scheduling and reviewing cleans

Scheduling cleans
Use the MyDyson™ app to schedule cleans for times when you're not at home,
or clean high traffic areas more frequently.
Reviewing cleans
Use the MyDyson™ app to see a map of where your robot has cleaned.
Your robot will update its map at the end and periodically during a clean.
You can use the map to see where your robot has got stuck during a clean,
then use this as a guide to add restrictions.
Your map will indicate the levels of dust detected during the clean, you may
want to clean areas with higher dust more often.

Looking after your robot

For optimum performance, regularly clean your robot and
check for obstructions.
Look after your robot
If your robot is dusty, wipe with a dry lint-free cloth.
Don't use detergents or polishes to clean your robot.
Keep your robot's software up to date with the MyDyson™ app.
Wash your filter
Wash your filter regularly and leave to dry completely.
Check airways for blockages
Check your robot regularly for blockages in the airways. Remove the bin and
check for debris in the airway behind it.
Check brush bar for obstructions
Check the brush bar regularly and remove any threads, hair and any other
debris that may cause an obstruction.
Check wheels for obstructions
Turn your robot over on a soft surface to protect the lens. Check that
the wheels are clear of any threads, hair or other debris that may
cause an obstruction.
Clean optics obstructions
Regularly check that your camera and sensors are clean and free from any
dirt or smears. Use a soft, dry, lint-free cloth to clean the optics.
Look after your battery
Your machine won't operate or charge if the ambient temperature is below
5°C (41°F). This is designed to protect both the motor and battery.
Register your robot
You'll need your serial number, located behind the bin.
For more information and support videos for your machine go online:
www.dyson.com/support
With the bin
removed, the
airway can be
found on the left
hand side of the
main body.
With the robot on its
back, look between
the roller bar and its
housing.
With the robot on
its back, check the
wheels located on
the bottom of the
robot, on either side.
With the robot
on its back, the
sensors can be
found on both
sides of the
bottom. There
are sensors on
the front corner
edge and two
pairs located
towards the bin.