Table of Contents
Advertisement
Side Panel
fig.Side
2
1
3
1. Security Slot (
http://www.kensington.com/
Preparations
Loading the Battery
fig.BattCase.e_50
1. Press down and slide off the lid of the battery compartment
(located on the bottom of the unit).
2. Connect the snap cord to the battery, and place it inside the
battery compartment.
* Verify the battery's polarity (+ versus -).
3. Securely close the battery cover.
* Do not let the snap cord get caught in the battery compartment lid.
When to Change the Battery
The Battery LOW indicator (
display begins to flash when the battery power drops.
Insufficient battery power lowers the volume level of the mini speaker and causes unstable
operation. Replace the battery as soon as possible.
Connecting the AC Adaptor
A BOSS PSA series AC adaptor (sold separately) can be used to power the RMP-3.
Turn off the power before connecting the AC adaptor.
Use only the BOSS PSA-series AC adaptor. Other adaptors may cause malfunction or damage
to the RMP-3 and must never be used.
The Battery LOW indicator (
adaptor is used.
Adjusting the Head Tension
fig.Bolt
BEFORE playing the RMP-3, you must tune the head to your preferred
playing tension. The head is NOT tuned before shipping.
Always tighten the tuning bolts in the order shown in the figure.
* Failure to adjust the tension may result in damage to the head.
* Head tension may change with extended use. Make adjustments as needed.
4
5
)
) at the lower left of the
2. MIX IN Jack
For connecting an external audio source
(CD, MD, etc.) for playing along.
3. OUTPUT Jack
For headphones, amp, or audio system.
* The RMP-3 outputs sounds in monaural.
4. AC Adaptor Jack
Connect the AC adaptor (optional) here.
5. POWER Switch
Turns the power on/off.
) flashes when the battery power drops while the AC
– 2 –
Battery
Snap
9V
Battery
8
1
3
6
5
4
2
7
Advertisement
Table of Contents
