Dell OptiPlex 5055 Small Form Factor Owner's Manual page 56

Option
Fan Control Override
USB Wake Support
Wake on LAN/WWAN
Block Sleep
Table 12. POST Behavior
Option
Numlock LED
Keyboard Errors
Warnings and Errors
Extend BIOS POST Time
Full Screen Logo
Table 13. Virtualization Support
Option
AMD-V Technology
AMD-VI Technology
Table 14. Maintenance
Option
Service Tag
Asset Tag
56 System setup
Description
Allows you to determine the speed of the system fan. When this option is enabled, the system fan
runs at the maximum speed. This option is disabled by default.
Allows you to enable the USB devices to wake the computer from standby mode. The option "Enable
USB Wake Support" is selected by default
This option allows the computer to power up from the off state when triggered by a special LAN
signal. This feature only works when the computer is connected to AC power supply.
• Disabled - Does not allows the system to power on by special LAN signals when it receives a
wake-up signal from the LAN or wireless LAN.
• LAN - Allows the system to be powered on by special LAN signals.
• WLAN Only - Allows the system to be powered on by special WLAN signals.
• LAN or WLAN- Allows the system to be powered on by special LAN signals or WLAN signals.
• LAN with PXE Boot - A wakeup packet sent to the system in either the S4 or S5 state, that will
cause the system to wake-up and immediately boot to PXE.
This option is Disabled by default.
Allows you to block entering to sleep (S3 state) in OS environment. This option is disabled by default.
Description
Allows you to enable or disable the Numlock feature when your computer starts. This option is
enabled by default.
Allows you to enable or disable the keyboard error reporting when the computer starts. This option is
enabled by default.
This option can speed up the boot process by bypassing some compatibility steps:
• Prompt on Warnings and Errors (enabled by default)
• Continue on Warnings
• Continue on Warnings and Errors
The options are:
• 0 seconds (default)
• 5 seconds
• 10 seconds
This options is disabled by default.
Description
This option is enabled by default.
This option is enabled by default.
Description
Displays the Service Tag of your computer.
Allows you to create a system asset tag if an asset tag is not already set. This option is set by default.