KTM 250 EXC SIX DAYS TPI 2022 Owner's Manual page 109

Note
Environmental hazard Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with
the applicable regulations.
Info
Never use DOT 5 brake fluid. It is silicone-based and purple in color. Oil seals and brake lines are not
designed for DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid corrodes paint.
Only use clean brake fluid from a sealed container.
S03488-10
E00351-10
E00352-10
E00353-01
–
Position the vehicle vertically.
–
1
Remove screw cap with membrane
–
Press the brake piston back into the basic position and ensure
that brake fluid does not flow out of the brake fluid reservoir;
extract some if necessary.
Info
Make sure that you do not press the brake caliper
against the spokes when pushing back the brake piston.
–
3
Remove cotter pin , pull out pin
linings.
–
Clean the brake caliper and the brake caliper bracket.
–
5
Check that spring plate
6
sliding plate in the brake caliper bracket are seated cor-
rectly.
–
Insert the new brake linings, insert the pin, and mount the cot-
ter pins.
Info
Always change the brake linings in pairs.
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
BRAKE SYSTEM 13
2
and the O-ring.
4
, and remove the brake
in the brake caliper and brake pad
107