Page 1
For your convenience, record the model number and serial number (you will find them on the bottom side of your set) in the space provided below. Please refer to them when you contact your AIWA dealer in case of difficulty. Model No. CDC-X217...
PRECAUTIONS TABLE OF CONTENTS • Use only in a 12-volt DC negative-ground electrical THEFT PROTECTION ..........2 system. BASIC OPERATION, AUDIO AND CLOCK • Disconnect the vehicle’s negative battery terminal ADJUSTMENT ............. 2 while mounting and connecting the unit. RADIO OPERATION ..........3 •...
THEFT PROTECTION BASIC OPERATION, AUDIO AND CLOCK Take the front panel with you when leaving the car, and keep it in the supplied carrying case. ADJUSTMENT Detaching the front panel Before detaching the front panel, remove the CD to prevent possible damage to the unit. Press z to remove the CD.
Adjusting sound Setting the clock You can select the following modes for adjusting sound Press and hold DISP until the clock indicator flashes depending on the music you listen to: BASS (low in the display. frequencies), TRE (high frequencies), BAL (left/right), Press TUNEi (to set hour) or TUNEk (to set FAD (front/ rear) and H-BASS (high bass) minute) and turn the Smart Jog.
Page 5
Presetting stations manually Local mode Local mode allows you to tune in only to strong stations (Manual Memory) during Seek Tuning. Press FNC repeatedly to select the desired band Press LO before you start seek tuning. (FM1, FM2, FM3, AM1 or AM2). “LO”...
Labeled-side up Press and hold INFO until the unit turns off, and setting is completed. When the unit is on, “MY INFO” appears in the display indicating that the unit is standby for a timer. During the timer-activated tuning, “MY INFO” continues to flash.
Follow the suggestions below to solve such problems. If the error code indication does You can listen to equipment connected to the unit. Refer not disappear, consult an AIWA service center. to the operating instructions for the corresponding equipment for more detailed information.