Table of Contents
Advertisement
Attention: Operating the system without the service access cover on for more than 10 minutes
when the system power is turned on might damage the system components.
Figure 3. Removing the service access cover
8. To activate the identify LED for the faulty part, press and hold push-button (A) on the trusted platform
module card as shown in the following figure.
Verify that the LED (B) is lit, which indicates that sufficient power exists for the identify LED. If the LED
(B) is not lit, use the location code to find the physical location by using the service label.
6 Power Systems: Trusted platform module
Advertisement
Table of Contents
