Table of Contents
Advertisement
Cleaning the Oven
Be sure all controls are off and all surfaces are cool before cleaning any part of the range. For surfaces not listed
here, see the full owner's manual at www.GEAppliances.ca.
Manual Cleaning:
liquid cleansers, steel wool, scouring pads, or cleaning
powders on the interior of the oven. Clean with a mild
soap and water or vinegar and water solution. Rinse with
clean water and dry with a soft cloth.
Self Clean Mode:
Instructions at the beginning of this manual before using
Self Clean Mode.
Self-clean (black) racks may remain in the oven. Close the
door. If the oven is too hot, you will not be able to start
self- clean. Press the Self Clean pad. Use the number
pads to enter any clean time between 3 and 5 hours and
press start. The oven door will lock. For a moderately
soiled oven, run a 3 hour self-clean cycle. For a heavily
Accessories
Looking For Something More?
GE Appliances offers a variety of accessories to improve your cooking and maintenance experiences!
To place an order visit us online at:
The following products and more are available at extra cost: Broiler Pan, Oven Racks and Cleaning Supplies
Troubleshooting
For additional troubleshooting tips, see the full owner's manual at www.GEAppliances.com.
Problem
Surface units do not
work properly or
flashing power setting.
My new oven doesn't
cook like my old one.
Is something wrong
with the temperature
settings?
Oven temperature too
hot or too cold
Oven light does not
work
Oven will not self-clean
Excessive smoking
during clean cycle
Oven door will not open
after a clean cycle
Do not use oven cleaners, strong
Read Self-Cleaning Oven Safety
www.GEAppliances.ca (Canada)
1.800.661.1616 (Canada)
Possible Cause
Improper cookware being used.
Pan is too small.
Pan not positioned correctly.
Pan is not in full contact with glass surface.
In some areas, the power (voltage) may be low.
A fuse in your home may be blown or the
circuit breaker tripped.
Cooktop controls improperly set.
Your new oven has a different cooking
system from your old oven and therefore
may cook differently than your old oven.
Oven temperature needs adjustment.
Light bulb is loose or defective.
Pad operating light is broken.
The temperature is too high to set a
self-clean operation.
Oven controls improperly set.
Excessive soil or grease.
Oven too hot.
soiled oven, run a 5 hour self-clean cycle. The oven will
turn off when the self-clean cycle is complete. The door
will not unlock until the oven has cooled below the unlocking
temperatures. After the oven has cooled down wipe ash
out of the oven.
Steam Clean Mode:
cleaning light soils. To use the Steam Clean feature, wipe
grease and soils from the oven. Pour one cup of water
into the bottom of the oven. Close the door. Press Steam
Clean then press Start. The oven door will lock. You
cannot open the door during the 30 minute steam clean.
When the cycle completes, soak up remaining water and
wipe the oven walls and door.
What To Do
Wrong pan type. Use a magnet to check that cookware is
induction-compatible. Use a flat induction-capable pan that meets
the minimum size for the element being used. See the Pan Size
and Shape section in full owner's manual.
Pan size is below the minimum size for the element. See the Pan
Size and Shape section in full owner's manual. Use smaller element.
Center the pan in the cooking zone.
Pan must be flat.
Cover pan with a lid until desired heat is obtained.
Replace the fuse or reset the circuit breaker.
Check to see that the control is set properly.
For the first few uses, follow your recipe times and temperatures
carefully. If you still think your new oven is too hot or too cold, you
can adjust the temperature yourself to meet your specific cooking
preference. NOTE: This adjustment affects Bake temperatures; it
will not affect Broil or Clean.
See the Special Features section.
Tighten or replace bulb.
Call for service.
Allow the oven to cool and reset the controls.
See the Cleaning the Oven section.
Press the Cancel/Off pad. Open the windows to rid the room of
smoke. Wait until the LOCKED light goes off. Wipe up the excess
soil and reset the clean cycle.
Allow the oven to cool below locking temperature.
The Steam Clean feature is for
7
Advertisement
Table of Contents
