Conair Precision Bikini BT2 - Trimmer & Shaver Manual

TROUBLESHOOTING

There are several things to look for if your trimmer fails to operate:

1. Be sure the trimmer is turned ON.
2. Make sure that the battery is properly placed in the battery compartment. Test the battery to be sure it is working.
3. Check the blades to see if they are clogged with hair clippings; if so, use a cleaning brush to remove hair.
4. If the trimmer still fails to operate, take or send it to a Conair Service Center (see warranty procedure and addresses).

FOR HOUSEHOLD USE ONLY

OPERATING INSTRUCTIONS

1. Remove the battery cover at the back of the unit by pulling straight down.
2. Being careful not to bend the clips, insert the negative end of the battery first, so it will slip easily into position.
3. Return the battery cover to its original position by pushing it into place.
4. To use your trimmer, push ON/OFF switch upwards to ON position.
5. After you finish using your trimmer, push down on the ON/OFF switch to turn the trimmer off.
6. Always purchase the correct size and grade of battery most suitable for the intended use.
7. Replace the battery once it is no longer functional.
8. Clean the battery contacts and also those of the devise prior to battery installation.
9. Ensure the batteries are installed correctly with regard to polarity (+ and -).
10. Remove batteries from equipment, which is not to be used for an extended period of time. 11. Remove used batteries promptly.
11. Store unused batteries in their original packaging, away from metal objects that could short-circuit them. Never short-circuit batteries.
12. Never dispose of batteries in fire, except under condi-tions of controlled incineration. Failure to observe this precaution may result in an explosion. Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.

*The BT2 requires 1 "aa" battery (not included). We recommend using alkaline batteries in your trimmer because they last longer. If you are not going to use your trimmer for a long period of time, or if the battery is dead, remove the battery from the unit. This will increase the life of your trimmer.

OUTLINING

Women whose skin is sensitive to cosmetics, easily irritated by trimming or who suffer from a skin allergy should test one section of leg or arm before using.

1. The bikini trimmer is especially useful for providing shape and definition. It is best to begin with clean slightly damp hair.
2. Beginning at the sides, use the cutting blades to define the shape.
3. If you would like to shorten your hair, run the blades over your hair until the desired length is achieved using even strokes.

TAKING CARE OF TRIMMER

BLADE CARE

Because the trimmer blades are precision made for a very special use, they should always be handled with care. Each time you finish using the trimmer, take a cleaning brush and brush away any loose hair that has collected in the blades.

TO CLEAN YOUR TRIMMER

Make sure trimmer is off.

1. To remove the trimmer head for cleaning, turn the head counter-clockwise until the "I" mark aligns with the "arrow" mark, then lift the head gently (Fig. 1).
   
2. Only rinse the head under water (Fig. 2). For proper functioning of the unit, the handle can not touch or be immersed in water.
   
3. After cleaning, make sure to shake dry the head before replacing it to the body.
4. To reassemble the head onto the body, align the "I" mark on the head with the "arrow" mark on the body and then turn clockwise until the "I" mark aligns with the "circle" mark on the body (Fig.3).
   

BT2 BIKINI TRIMMER

www.conair.com/registration

©2014 Conair Corp.
Service Center
Conair Corporation
Service Department
7475 North Glen Harbor Blvd.
Glendale, AZ 85307