LG LS240HLV Owner's Manual page 10

Unit operAtion
Remote Controller
installing remote controller batteries
1. Insert AAA batteries (1.5V) before turning on the remote.
2. Remove the battery cover from the back of the unit, by pushing down the tab at
the top of the cover. Refer to #1 on Figure 4.
3. Lift battery cover off of the unit as shown on Figure 4 (#2).
4. Insert the batteries, following the + and - terminal indications inside the battery
compartment. Make sure batteries are securely in place (Figure 5).
5. Reattach the battery cover.
• If the display screen of the remote controller starts to fade, replace the batteries.
• When batteries are removed, the temperature unit will be reset to Celsius as the
default.
installing the remote controller Holder
Installation of the remote controller holder should be out of direct
sunlight, in order to protect the remote controller from heat exposure.
1. Choose a safe and easily accessible place to attach the remote controller holder.
2. Using a phillips head screwdriver, insert and fasten the 2 screws into the holes at
the base (Figure 6).
3. Gently "wiggle" the base to make sure that it is firmly attached to the wall. Tight-
en the screws further if you feel the wall mount is still loose.
4. Slide the remote control vertically into the holder (Figure 7).
Figure 7: Insertion of Remote into Holder
10
Due to our policy of continuous product innovation, some specifications may change without notification.
©
LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 4: Remote Control Battery Cover
Figure 5: Battery Placement
Figure 6: Holder Attachment