Table of Contents
Advertisement
Quick Links
MAGICFLAME™
FIRE AND WATER BOWL
INSTALLATION AND USER'S GUIDE
FOR YOUR SAFETY - READ BEFORE OPERATING!
If the information in this manual is not followed exactly, a fire or explosion may
result causing property damage, personal injury, or loss of life. For additional free copies of this
manual; call (800) 831-7133.
RISK OF FIRE OR EXPLOSION! Improper installation and/or servicing can
result in flammable gas leaks, which could result in death, serious injury, or
major property damage.
FIRE OR EXPLOSION HAZARD!
IF YOU SMELL GAS:
• Shut off gas to the appliance.
• Extinguish any open flame.
• If odor continues, leave the area immediately.
• After leaving the area, call your gas supplier or fire department.
Failure to follow these instructions could result in fire or explosion, which could cause
property damage, personal injury, or death.
FOR OUTDOOR USE ONLY! Installation and service must be performed by a
qualified installer, service agency, or the gas supplier.
Do not store or use gasoline, or other flammable vapors and liquids, in the
vicinity of this or any other appliance.
An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other
appliance.
CARBON MONOXIDE HAZARD! This appliance can produce carbon monoxide
which has no odor.
Using this appliance in an enclosed space can kill you. Never use this appliance in an enclosed
space such as a camper, tent, car, or home.
INSTALLER: LEAVE THIS MANUAL WITH THE APPLIANCE.
CONSUMER: RETAIN THIS MANUAL FOR FUTURE REFERENCE.
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Advertisement
Table of Contents
Related Manuals for Pentair MagicFlame 580165
Summary of Contents for Pentair MagicFlame 580165
- Page 1 MAGICFLAME™ FIRE AND WATER BOWL INSTALLATION AND USER’S GUIDE IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS FOR YOUR SAFETY - READ BEFORE OPERATING! If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury, or loss of life.
-
Page 2: Important Safety Instructions
Only a qualified service professional or gas supplier should attempt to convert equipment. Ensure this guide is given to the pool owner and/or operator of from one fuel to the other. If fuel conversion is necessary, consult your Pentair this equipment after installation. - Page 3 IMPORTANT SAFETY INSTRUCTIONS If burner goes out, turn gas to off position and wait several For countries in compliance with International minutes. Once gas has dissipated, light following the Electrotechnical Commission (IEC) regulatory standards: manufacturer’s recommendations. The fire feature must be installed by a licensed or certified electrician or other qualified professional, in accordance with IEC 364-7-702 and all applicable DO NOT USE SOLID FUELS.
-
Page 4: Table Of Contents
CUSTOMER SERVICE / TECHNICAL SUPPORT Hours: 9:00 to 7:00 EST (6:00 - 4:00 PST) Call: (800) 831-7133 Visit: www.pentair.com Fax: (800) 284-4151 TABLE OF CONTENTS IMPORTANT SAFETY INSTRUCTIONS ....MAINTENANCE ............ General Maintenance INSTALLATION ............Annual Maintenance Feature Overview Winterizing the Fire Feature... -
Page 5: Installation
IMPORTANT! The fire feature is shipped from the manufacturer for use natural gas at the manufacturer. If conversion to propane is required, it must be performed by a qualified service professional or gas supplier using Pentair specified and approved parts. - Page 6 INSTALLATION GUIDELINES (continued) • Minimum 15 GPM [56.8 LPM] flow for water features. • If the pool has multiple lights, water features, etc., it is recommended that the fire/water features be run independent of each other, using a separate transformer for each group or type of water feature. Otherwise all water features connected to the same transformer will operate together.
-
Page 7: Bowl Dimensions
BOWL DIMENSIONS 32” 11” [81.3] [27.9] 35” [88.9] 35” [88.9] 1” 1” 19” [48.3] [2.5] [2.5] 19” [48.3] 3” 3” [7.6] 15” [7.6] 15” [38.1] [38.1] 15” [38.1] 14” 14” [35.6] [35.6] 0.75” 0.75” [1.9] [1.9] 15” [38.1] 14” [35.6] 15”... -
Page 8: Gas Requirements
GAS REQUIREMENTS To verify the fuel type (either propane or natural gas) the fire feature is designed to use, refer to the label on the bottom of the control box. Natural Gas (NG) Requirements Propane Gas (LP) Requirements Ensure that the service supplying the fire feature is fitted RISK OF EXPLOSION IF UNIT IS INSTALLED with a positioned shut off valve that is easily accessible. -
Page 9: Pipe Sizing Charts
PIPE SIZING CHARTS The sizing charts below list the specific pipe sizes required for the amount of BTUs for new gas line installations. If you are using an existing gas line you must consider existing gas line capacities to ensure proper pressure. Consult a qualified service professional or gas supplier for more details. -
Page 10: Gas Line Installation
GAS LINE INSTALLATION Keep pipe length and elbows to a minimum to eliminate unnecessary pressure drops. Corrugated flex gas lines should not be used. 1. Determine the proper gas line size based on fuel input requirements (BTU/HR), gas pressure and the distance from the gas pressure regulator to the fire/water bowl. -
Page 11: Electrical Installation
ELECTRICAL INSTALLATION When using multiple fire features, the total allowable wattage is 300 Watts. A transformer should only be loaded to 80% of its capability. For example: A 300 watt transformer should have no more than 240 watts attached to it. A single MagicFlame is 60 Watts maximum. -
Page 12: Bowl Installation
BOWL INSTALLATION 5. Using a 3/8-inch concrete drill, drill down a Water Bowls: minimum of 4 inches [10.2 cm] at all four marked Water bowls must be leveled, centered or placed in the locations. See FIGURE 5. desired position and secured to the mounting surface. Once this is complete, the center hole must be sealed and filled in such a way that water will not leak through the water inlet pipe and onto the mounting surface. - Page 13 FIGURE 6 MAGICFLAME™ Fire and Water Bowl Installation and User’ s Guide...
-
Page 14: Installing The Burner Assembly
INSTALLING THE BURNER ASSEMBLY The fire feature includes a burner assembly and control box. The burner and control box will need to be connected to the gas and electrical supply lines. 1. Before installing the burner assembly, ensure the correct pilot and burner orifices are installed. a. -
Page 15: Adding Fire Media
ADDING FIRE MEDIA ONLY use approved fire media, correctly distributed, to ensure safety and proper combustion. Never use non-porous material, or any material that holds moisture, such as gravel, pebbles, river rock, etc. When heated, non-porous material will not allow steam to properly vent which can result in the material fracturing and causing personal injury or property damage. -
Page 16: Operation
The fire feature can also be controlled via most Pentair automation systems. For more information refer to your specific automation system’s manual. -
Page 17: Maintenance
MAINTENANCE RISK OF FIRE OR EXPLOSION! Improper installation and/or servicing can result in flammable gas leaks, which could result in death, serious injury, or major property damage. Installation and servicing must be performed by a qualified service professional or gas supplier. RISK OF CARBON MONOXIDE POISONING OR ASPHYXIATION! This product can produce carbon monoxide, a tasteless and odor-less toxic gas. -
Page 18: Replacing The Pilot Orifice
REPLACING THE PILOT ORIFICE The pilot orifice is located at the base of the pilot/igniter assembly and the burner orifice is located at the end of the main burner pipe. Each orifice is specific for either Natural Gas or Propane. 1. -
Page 19: Replacing The Pilot/Igniter Assembly
REPLACING THE PILOT/IGNITER ASSEMBLY 1. Turn off the electrical and gas supply to the fire feature. 2. Remove fire media from the bowl. Fire media may still be hot after the fire feature is shut off. To prevent personal injury, ALWAYS allow the fire media to cool before redistributing. -
Page 20: Replacing The Burner Orifice
OF THE BURNER CAN OCCUR WHICH MAY RESULT IN DEATH. Only a qualified service professional or gas supplier should attempt to convert from one fuel to the other. If it is necessary to convert to a different type of gas, consult your Pentair dealer. 1. Secure the support plate. - Page 21 REPLACING THE BURNER ORIFICE (CONT.) 12. Position the heat shield and tighten the jam nut by hand until it holds the heat shield in place. 13. Using a wrench, tighten the jam nut until the heat shield is firmly secured. 14.
-
Page 22: Replacing The Pilot Sensor
REPLACING THE PILOT SENSOR 1. Turn off the electrical and gas supply to the fire feature. 2. Remove fire media from the bowl. Fire media may still be hot after the fire feature is shut off. To prevent personal injury, ALWAYS allow the fire media to cool before redistributing. -
Page 23: Troubleshooting
TROUBLESHOOTING RISK OF FIRE OR EXPLOSION! Improper servicing can result in flammable gas leaks, which could result in death, serious injury, or major property damage. All servicing must be performed by a qualified service professional or gas supplier. RISK OF CARBON MONOXIDE POISONING OR ASPHYXIATION! This product can produce carbon monoxide, a tasteless and odor-less toxic gas. -
Page 24: Replacement Parts
REPLACEMENT PARTS ITEM DESCRIPTION 590293 Spillway (Square, Water Only) 590294 Spillway (Round, Water Only) 590295 Spillway (Square, Fire/Water) 590296 Spillway (Round, Fire/Water) 590283 Burner 590303 Pilot Hood 590301 Support Plate (Square, Fire Only) 590302 Support Plate (Round, Fire Only) 590292 Support Plate (Square, Fire/Water) 590284 Support Plate (Round, Fire/Water) - Page 25 REPLACEMENT BURNER ORIFICES (ITEM #5) INSTALL NATURAL PROPANE ELEVATION <4000 ft. 590280 590282 [<1219 m] 4000 – 6000 ft. 590318 590321 [1219 – 1829 m] 6000 – 8000 ft. 590319 590322 [1829 – 2438 m] 8000 – 10000 ft. 590320 590323 [2438 –...
- Page 26 1620 HAWKINS AVE., SANFORD, NC 27330 • (919) 566-8000 10951 WEST LOS ANGELES AVE., MOORPARK, CA 93021 • (805) 553-5000 All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.