Table of Contents
Advertisement
REVERSING THE DOOR
We recommend that you reverse the
door before switching on for the first
time.
Tools required: Small and medium size
flat and cross-headed screwdrivers, a
pair of pliers.
Spare Parts supplied in the plastic
bag: The following parts, which are
exclusively for left hand side fitted
hinge operation are supplied in a
plastic bag with the appliance:
- Door top trim hinge covers – there
are 2 different parts, one for each side
of top trim.
We suggest you keep all the parts
supplied in the plastic bag and also
parts, which have been removed when
reversing the door, in a safe place for
possible future, re-use.
IMPORTANT: We suggest you ask
somebody to help you when moving
the appliance around and to hold the
door when removing / re-fitting hinges
and the door to avoid any injury and
damage to the product.
Please refer to diagrams supplied. To
follow numbers in brackets below, refer
to the main diagram.
1.Switch off the appliance at the
socket outlet and pull out the mains
plug.
2.Remove all loose items and fittings
and food inside the appliance.
3.Gently prise off plastic hinge covers
on both sides of front top panel using a
small flat-headed screwdriver. (1-2)
4-Unscrew the bolts of the top hinge
and remove top hinge. (3)
5-Remove door carefully off the bottom
hinge and stand door upright in a safe
place.(4)
6.Gently prise off plastic hinge cover
on door top trim. Fit the other door top
trim plastic off hinge cover supplied in
the plastic bag.(5)
7.Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed.Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this.Once you tilt the
appliance back, check to make sure
the appliance is completely stable and
safe before you carry on. (6)
8.Unscrew and remove the front feet
and 1 bolt. (7)
9-Unscrew and remove the bottom
hinge. (8)
10-Unscrew and remove the bottom
hinge door stopper and bushing and
reposition them on the other side while
rotating the bushing 180°. (9)
11- Fit the bottom hinge and tighten
the screws as shown in figure. (10)
12- Fit the other front feet as shown in
figure. (11)
13- Rotate the top hinge 180°.
Unscrew the hinge pin and re-tighten it
to the opposite side. (12)
14-Fit the top hinge on the left hand
side bushing of the door. (13)
15-Locate and re-fit door to bottom
hinge pin. (14)
16-Re-fit the upper hinge on the
opposite side by using a flat headed
screwdriver. (15)
17.Fit front top panel plastic hinge
covers on the opposite sides. (16)
18-Adjust the two front feet if
necessary.
12
EN
Advertisement
Table of Contents
