Hints And Tips - JVC UX-D457S Instruction Manual

Hints and Tips

If a problem does occur, it may often be due to something very minor. The following table
contains various tips. If you require additional assistance
For UK, please call our UK Call Centre on 0344 561 1234.
•
For Ireland, please call our Ireland Call Center on 1 890 818 575.
•
General
Problem
No power.
The remote control does
not function.
No sound from the unit.
The unit does not
respond when pressing
any buttons.
AUX mode
Problem
The unit sometimes
switches back to standby
mode automatically.
CD
Problem
Disc in place but the unit
won't play.
Disc skips
30
Solution
• Ensure the mains plug is connected.
• Make sure that you select the ON mode.
• Use the remote control near the unit.
• Point the remote control at the remote sensor on the unit.
• Replace the battery in the remote control with a new one.
• Remove any obstacles between the remote control and
the unit.
Please try either one of the solutions below:
• Make sure that the unit is not muted. Press the
VOL + / – on the remote control, or turn the – VOLUME +
dial on the unit to resume normal listening.
• Press on the unit or on the remote control to switch
the unit to standby mode. Then press the button again to
switch the unit on.
• Unplug the unit from the mains socket, then plug it in
again. Switch on the unit.
• The unit may freeze up during use. Switch the unit off and
then on again at the mains socket to reset the unit.
Solution
• When the input signal is close to mute or the unit is idle
for approximately 15 minutes, it will automatically switch
to standby mode. Please increase the volume level of
your external device.
Solution
• Make sure you've selected CD mode.
• Make sure the disc label is facing up.
• Make sure the disc is clean.
PAUSE mode may be activated, deactivate it.
•
• Disc may be damaged or dirty; check and clean the disc.
• Make sure the unit is on a secure spot. Vibrations or
jarring can cause the disc to skip.
or the