Table of Contents
Advertisement
Overview
5
48 10GBASE-T copper ports (supporting
100-Megabit, 1-Gigabit, and 10-Gigabit speeds)
for connections to Application Policy
Infrastructure Controllers (APICs)
To determine which transceivers, adapters, and cables are supported by this switch, see the
Modules Compatibility Information
The following figure shows the hardware features seen from the fan side of the chassis.
1
Screw holes (2) for attaching the grounding lug.
2
Notch in both sides of the chassis for locking the fan
end of the chassis to the bottom-support rails.
3
Two power supply modules (AC power supply shown)
Power supply slots are numbered 1 on the left and 2
on the right (as seen when looking at the power
supplies).
4
Three fan modules (2 used for operations and one
used for redundancy) of the following types:
Fan slots are numbered 1 (leftmost slot) to 3
(rightmost slot).
Depending on whether you plan to position the ports in a hot or cold aisle, you can order the fan and power
supply modules with port-side intake or port-side exhaust airflow. For port-side intake airflow, the fan and
AC power supply modules have burgundy coloring (DC power supply modules have green coloring). For
port-side exhaust airflow, the fan and AC power supplies have blue coloring (DC power supply modules have
gray coloring).
10
Screw holes (2) for attaching a front-mount
bracket for four-post racks (one bracket on each
of two sides)
document.
5
6
7
Cisco Nexus 9396TX ACI-Mode Switch Hardware Installation Guide
Cisco Transceiver
Chassis LEDs are as follows:
• Beacon (BCN)
• Status (STS)
Screw holes (4) for attaching a center-mount rack
bracket for two-post racks (one bracket for each of
two sides).
Screw holes (2) for attaching a front-mount bracket
for 4-post racks (1 bracket on each of 2 sides).
Overview
3
Advertisement
Table of Contents
