Cuisinart CPO-800 - PurePrecision Pour-Over Coffee Brewer Manual

IMPORTANT SAFEGUARDS

For your safety and continued enjoyment of this product, always read the instruction book carefully before using.
When using electrical appliances, basic safety precautions should always be taken to reduce the risk of fire, electric shock and/or injury to persons, including the following:

1. READ ALL INSTRUCTIONS.
2. Always unplug from outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts and before cleaning the appliance.
3. Do not touch hot surfaces. Use handles and knobs.
4. To protect against electric shock, do not place cord, plug, or base unit in water or other liquids.
5. This appliance should not be used by or near children or individuals with certain disabilities.
6. Do not operate any appliance with a damaged cord or plug, or after the appliance malfunctions or has been dropped or damaged in any manner. Return appliance to the nearest Cuisinart Repair Center for examination, repair, and electrical or mechanical adjustment.
7. The use of accessory attachments not recommended by Cuisinart may cause injuries.
8. Do not use outdoors.
9. Do not let cord hang over edge of table or counter, or touch hot surfaces.
10. Do not place on or near a hot gas or electric burner, or in a heated oven.
11. A lways fill water reservoir first, then plug cord into the wall outlet. To disconnect, push the BREW/OFF button, then remove plug from wall outlet.
12. Do not use appliance for other than its intended use.
13. Snap lid securely onto carafe before serving any beverages.
14. Scalding may occur if the lid is removed during the brewing cycle.
15. The glass carafe is designed for use with this coffee brewer only. It must never be used on the range top.
16. Do not set a hot carafe on a wet or cold surface.
17. Do not use a cracked carafe or a carafe having a loose or weakened handle.
18. Do not clean carafe or heating plate with cleansers, steel wool pads, or other abrasive materials.
19. 
    TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE THE BASE PANEL.
    NO USER-SERVICEABLE PARTS ARE INSIDE. REPAIRS SHOULD BE DONE ONLY BY AUTHORIZED PERSONNEL.
20. Do not place cloth beneath coffee brewer or otherwise restrict airflow.
21. Use only the Cuisinart^® Laser-Etched Stainless Steel Filter, a gold tone filter, or standard #4 cone paper filter with this unit. OTHER PERMANENT FILTERS MAY CAUSE THE COFFEE BREWER TO OVERFLOW.
22. Do not operate your appliance in an appliance garage or under a wall cabinet. When storing in an appliance garage, always unplug the unit from the electrical outlet. Not doing so could create a risk of fire, especially if the appliance touches the walls of the garage or the door touches the unit as it closes.
23. The container is designed for use with this appliance. It must never be used on a range top.

SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY

RISK OF FIRE OR ELECTRIC SHOCK
The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated, dangerous voltage within the product's enclosure that may be of sufficient magnitude to constitute a risk of fire or electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

SPECIAL CORD SET INSTRUCTIONS
A short power-supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a longer cord.
Extension cords may be used if care is exercised in their use.
If an extension cord is used, the marked electrical rating of the extension cord must be at least as great as the electrical rating of the appliance, and the longer cord should be arranged so that it will not drape over the countertop or tabletop where it can be pulled on by children or tripped over.

NOTICE
This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not modify the plug in any way.

OPERATING NOTICE
Clogging and backing up of water and/or coffee in the filter basket can occur under any or a combination of any of the following conditions: The use of too finely ground coffee, using two or more paper filters, using the stainless steel filter in conjunction with a paper filter, or not properly cleaning coffee grounds from the stainless steel filter, or allowing coffee grounds to spill over the filter.

Never open the filter basket during the brewing cycle, even if no water is draining from the filter basket, because extremely hot water/coffee can spill out from the filter basket and cause injury. If water/ coffee is not draining from the filter basket during the brewing cycle, unplug the unit and wait 10 minutes before opening and checking the filter basket.

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE PERSONNEL ONLY

IMPORTANT UNPACKING INSTRUCTIONS

1. Place the box on a large, sturdy, flat surface.
2. Remove literature.
3. Turn the box so that the back side of the coffee brewer is down and slide the coffee brewer from the box.
4. After the coffee brewer has been removed, place the box out of the way and lift off the left and right inserts.
5. Grasp the carafe by its handle, remove it from the heating plate, and remove the polybag.
6. Remove the polybag covering the coffee brewer.

Save all packing materials in case you have to ship the machine in the future.
KEEP ALL PLASTIC BAGS AWAY FROM CHILDREN.

FEATURES AND BENEFITS

1. Coffee Brewer Lid
   Opens to access filter basket.
2. Water Reservoir with
   Water Level Indicator Window
3. Showerhead (not shown)
   Distributes water evenly over coffee, reducing temperature loss as water passes through grounds.
4. Charcoal Water Filter Holder
   Holds water filter firmly in place.
5. Charcoal Water Filter
   Eliminates chlorine, bad tastes and odors from tap water.
6. Filter Basket
   Holds a #4 paper filter, a stainless steel filter, or gold tone filter.
7. Cuisinart^® Laser-Etched
   Stainless Steel Filter
   Eliminates the need for paper filters. NOTE: Some fine grounds may flow through the filter and appear as sediment in the carafe.
8. Control Panel
9. Brew Pause^™
   Stops flow of coffee from basket when carafe is removed (20 seconds max) from the heater plate, so a cup can be poured mid-brew.
10. 8-Cup Glass Carafe
    The easy-pour carafe has an ergonomic handle and brewed coffee markings for 2 to 8 cups.
11. 60-Second Reset (not shown)
    One-minute protection in case a breaker trips, the unit is unplugged, or the power fails. It holds all programmed information, including time of day, Auto On time and Auto Off time.
12. Measuring Scoop
13. BPA Free (not shown)
    All parts that come in contact with coffee or liquids are BPA free.

GETTING TO KNOW YOUR CONTROL PANEL

1. Brew/Off
   Pressing BREW/OFF will start the brewing cycle. It can also be used to stop the brew cycle.
2. Menu
   Lets you navigate to each function on the display panel. Press once for STRENGTH, twice for TEMP, three times for AUTO OFF, four times for CLOCK and five times for CLEAN START.
   1. Strength
      Lets you choose from MILD, MEDIUM or BOLD coffee flavor.
   2. Temp
      Choose from HOT or X-HOT for your temperature preference.
   3. Auto Off
      Use to select desired amount of time until keep warm function shuts off from 0–2 hours.
   4. Clock
      Navigate here to set the time on your coffee brewer.
   5. Clean Start
      CLEAN flashes when you need to clean coffee brewer.

3. Auto On
   Lets you program coffee brewer to automatically begin brewing up to 24 hours in advance. AUTO ON illuminates on panel when set.
4. 
   Arrows
   Used to select STRENGTH and TEMP settings. Also used to set the clock.
   ( for Hour for Minute)

BEFORE BREWING YOUR FIRST POT OF COFFEE

RINSING YOUR COFFEE BREWER:
We recommend flushing out the system before brewing your first pot of coffee. Simply fill the reservoir, power on the unit, and follow steps 1, 3 and 5 under MAKING COFFEE. Do not add coffee!

Charcoal Water Filter
Your coffee brewer comes with a charcoal water filter that eliminates chlorine, bad tastes and odors from tap water.

Inserting the Water Filter

• Remove the filter from polybag and soak it, fully immersed, in cold tap water for 15 minutes.
• Lift the water filter holder out of the water reservoir.
• Press down on the filter compartment and pull toward you to open.
• Place filter into the holder and snap it closed. Be careful – improper placement can tear the filter skin.
• Flush filter by running cold tap water through holes in bottom of compartment for 10 seconds.
• Allow the filter to drain completely.
• Slide the water filter holder back into the channel in the water reservoir, pushing it down to the base of the unit.

NOTE: We recommend changing the water filter every 60 days or after 60 uses, and more often if you have hard water.

Replacement filters can be purchased in stores, or by calling Cuisinart Customer Service, or at www.cuisinart.com

PROGRAMMING YOUR COFFEE BREWER

SETTING THE CLOCK
When the coffee brewer is plugged in, 12:00 will flash in the display for 30 seconds, indicating the unit is in Clock Set mode. If 12:00 stops flashing, simply press the menu button 4 times to the clock option and the time will return to flashing Clock Set mode.

SETTING HOURS AND MINUTES
Use the up arrow to set hours and the down arrow to set minutes. Hold buttons down to scroll through the digits quickly, or press and release to advance one digit at a time. Be sure the PM indicator is on if setting a PM time. Once time is correct, press MENU to set, or five seconds after finishing, the unit will automatically exit Clock Setting mode.

AUTO ON FUNCTION

SETTING THE AUTO OFF TIME

MAKING COFFEE

First, follow instructions in BEFORE BREWING YOUR FIRST POT OF COFFEE.

1. Fill the water reservoir
   Lift the coffee brewer lid to open. Pour the desired amount of water into the water reservoir using the water level indicator located at the front of the coffee brewer.
2. Add the ground coffee
   Insert a #4 paper filter, gold tone filter, or the stainless steel etched filter. If using a paper filter be sure that the paper filter is completely open and fully inserted in the basket. It may help to fold and flatten the seams of a paper filter beforehand. Add 1–1½ level scoops (tablespoons) of ground coffee per cup. Adjust the amount according to taste. NOTE: The maximum capacity for ground coffee is 11 tablespoons for this coffee brewer. Exceeding this amount may cause overflow if the coffee is too finely ground.
3. Position carafe and plug in unit
   Place carafe on heating plate and make sure filter basket is securely in place and lid is completely closed. Plug coffee brewerinto an electrical outlet.
4. Set preferences
   1. Press MENU once to get to strength. Use up/down arrows to choose mild, medium or bold. Press MENU again to set and you will be moved to the next setting.
   2. You are now on TEMP. Use up/down arrows to select hot or X-hot. Press Menu to set.

5. Start Brewing
   Press the Brew/Off button to begin brewing, the on button will illuminate.
6. After brewing
   When the brew cycle is complete, 5 beeps will sound.
   NOTE: Reservoir cover may be hot during and directly after brewing. Wait at least 10 minutes before opening.

SCAA COFFEE DOSE RECOMMENDATIONS

SCAA APPROVED SETTINGS

• Strength: Medium
• Temperature: Hot
  NOTE: This is the default setting of your pour over coffee brewer, but can be adjusted according to your preference.

SCAA APPROVED!

Cuisinart's high standards have passed the tests of the Specialty Coffee Association of America. Our Cuisinart ® PurePrecision™ Pour-Over Coffee Brewer proudly carries their seal of approval, having met the SCAA's rigorous technical requirements for exemplary home brewers. For more information on SCAA go to: http://www.scaa.org
BLOOMING
After coffee grounds are evenly showered with water heated to the ideal brewing temperature, the unit pauses to let the flavor bloom before proceeding with the brewing process.

BREW PAUSE™ FEATURE

This feature interrupts the flow of coffee from the basket to let you pour that first cup midbrew. Because the flavor profile of coffee brewed at the start of a cycle differs from that brewed toward the end, be aware that using this feature will weaken the flavor strength of the finished pot.
NOTE: Removing carafe for more than 20 seconds during brew cycle may cause filter basket to overflow.

CLEANING AND MAINTENANCE

Always turn coffee brewer off and remove the plug from the electrical outlet before cleaning.
Lift up the coffee brewer lid. Remove and discard the paper filter and ground coffee. The filter basket can be washed in warm, soapy water and rinsed thoroughly, or cleaned on the upper rack of the dishwasher. Dry all parts after use.
Do not put any water in the unit once the filter basket has been removed. Wipe the area under the filter basket with a damp cloth.
Remove the carafe from the heating plate. Discard any remaining coffee. The carafe and lid can be washed in warm, soapy water and rinsed thoroughly, or placed in a dishwasher. The carafe and carafe lid should be placed on the upper rack only.
Do not use any scouring agents or harsh cleansers on any part of the coffee brewer.
Never immerse base unit in water or other liquids. To clean base, simply wipe with a clean, damp cloth and dry before storing. Fingerprints and other blemishes on the housing can be washed off with soap and water or a nonabrasive cleaning solution. Wait for heating plate to cool, then wipe with a clean, damp cloth. Never use rough, abrasive materials or cleansers to clean the heating plate. Do not dry the inside of the water reservoir with a cloth, as lint may remain.

Maintenance
Any other servicing should be performed by an authorized service representative.

Decalcification

Decalcification refers to the removal of calcium deposits that form over time on the metal parts of your coffee brewer. The mineral content of the tap water in your area and the frequency of use affects the rate of the calcium buildup, which can affect the functioning of your coffee brewer and the flavor of your coffee.
For best performance from your PurePrecision™ Pour-Over Coffee Brewer, we recommend cleaning it whenever CLEAN is flashing on your control panel.
NOTE: Before decalcifying your unit, remove the charcoal water filter from the water reservoir.

To clean:

1. Fill the water reservoir to capacity with a mixture of ¹⁄₃ white vinegar and ²⁄₃ water.
2. Press MENU button 5 times to get to clean start. Press BREW/OFF to begin cleaning cycle.
3. When the cycle is completed, 5 beeps will sound and the coffee brewer will shut off.
4. If CLEAN flashes once more, repeat the cleaning procedure with a fresh solution of vinegar and water.
   NOTE: One cleaning cycle is usually sufficient.
5. When CLEAN remains off, run one cycle with a full reservoir of fresh, cold water to rinse the unit.
6. Return the charcoal water filter to the holder inside the water reservoir and your coffee brewer is ready to brew!