Table of Contents
Advertisement
D
OOR STATION INSTALLATOIN
Door stations are an intercom speaker that mounts by a
home entrance door. Models are available with and without
a doorbell button.
1. At each Door Station location, strip approximately 4 inches of jacket
from the cables and separate the colored wires. Strip 1/2 inch of
insulation from each wire.
2. At the Door Station end of the cable, cut off the cable's drain wire (the
shield wire) all the way back to the cable sheath to prevent it from
shorting to any Door Station parts.
3. If the Door Station has a bell button, connect the YELLOW and
ORANGE to the bell button's screw terminals (either wire to either
terminal).
4. Use a wire nut to connect the RED wire to the RED Door Station
speaker wire.
5. Use a wire nut to connect the BLACK wire to the BLACK Door Station
speaker wire.
6. Tuck the wires into the enclosure and mount the Door Station using
the two screws provided.
S
ATELLITE VOLUME CONTROLS
Monaural 45-ohm speakers can be connected to the dmc1
Master Station to distribute radio, CD, or portable music
player sound throughout the installation. Each mono speaker
is controlled by a single Model MVC1 (white) or MVC1A
(almond) volume control that mounts in a single-gang J-box.
CAUTION
ANY SPEAKER CONNECTED TO THE DMC1 MUST BE 45 OHMS!
Do not connect any 8 ohm speakers or damage to the dmc1
Master Station will occur!
Use wire nuts for the following connections.
1. At each volume control location, strip approximately 4 inches of
jacket from the cables and separate the colored wires. Strip 1/2 inch
of insulation from each wire.
2. Connect the SHIELD wire from the MS2SX5SC cable that goes to
the speaker location to the RED wire from the MVC1 volume control
and to the BROWN and WHITE/BLUE wires from the Cat-5 cable that
goes to the dmc1 Master Station. (Four wires in this wire nut, this is
the ground connection.)
3. Connect the GREEN and WHITE/BROWN wires from the Cat-5 cable
that goes to the dmc1 Master Station to the GREEN wire from the
MVC1 volume control. (Three wires in this wire nut, this is the audio
signal connection.)
4. Connect the BLUE wire from the MS2SX5SC cable that goes to the
speaker location to the BLUE wire from the MVC1 volume control.
(Two wires in this wire nut, this is the speaker – connection.)
5. Connect the VIOLET wire from the MS2SX5SC cable that goes to the
speaker location to the VIOLET wire from the MVC1 volume control.
(Two wires in this wire nut, this is the speaker + connection.)
6. Tuck the wires into the J-box and mount the MVC1 volume control to
the J-box using the two screws provided.
BLACK
RED
MS4DCXSC
CABLE
FROM MASTER
Figure 5. Door Station Installation
WARNING !!!
USE ONLY A 45-OHM
INTERCOM SPEAKER
OR DAMAGE TO MASTER
MAY OCCUR !!!
SHIELD WIRE
CAT-5 CABLE
FROM MASTER
BROWN &
BLUE / WHITE
THESE WIRES ARE
NOT CONNECTED
GREEN &
BROWN / WHITE
Figure 6. MVC-1 Volume Control Wiring
ORANGE
YELLOW
45-OHM
INTERCOM
SPEAKER
BLUE
VIOLET
MS2SX5SC
SPEAKER
VIOLET
CABLE
RED
MVC1
MONAURAL
VOLUME
CONTROL
GREEN
BLUE
3
Advertisement
Table of Contents
