Cub Cadet Enduro Series Operator's Manual page 10

3. Rotate the seat into position and secure the seat into place
with the previously removed shoulder screws and flange
lock nuts. Be careful not to crimp or damage the wire
harness while installing the seat. See Figure 3-3.
4. Using the harness clip attached to the harness, secure the
excess wire to the fender by snapping the harness clip in
place as shown in Figure 3-4.
Lower Deck Discharge Chute Deflector
WARNING!
without the chute deflector installed and in the
down position.
1. Remove the keys that are attached with a zip tie to the
chute bracket.
10 S 3— A
ection SSembly
Figure 3-3
Figure 3-4
Never operate the mower deck
& S -U
et p
On units with 42" and 46" decks :
2. Check the mower deck for shipping braces (with tags) that
may be holding the chute deflector upward for shipment.
If braces are present they must be removed before
operating the tractor. Holding the chute deflector fully
upward, remove each shipping brace by grasping it and
rotating it clockwise. Lower the chute deflector. See Figure
3-5.
Figure 3-5
On units with 50" and 54" decks :
3. Remove the flange lock nut and hex screw from the deck.
4. Place the chute deflector on the deck, be sure to insert the
tabs on the chute deflector into the holes on the deck. See
Figure 3-6.
3
5
Figure 3-6
5. When the tabs are installed in the deck, slide the chute
deflector toward the rear of the tractor until the bolt hole
in the chute deflector aligns with the hole in the deck. See
Figure 3-6.
5
4
4