Camera Adaptor Power Supply - Sony Power HAD EX DXC-D55PK Operating Instructions Manual

Battery pack charging
Before using a battery pack, charge it as shown in the
following table.
For details of battery charger operation, refer to the
instructions provided with the battery charger to be used.
Battery pack Battery charger
BP-GL65, BP-GL95 BC-M150, BC-L70, AC-DN10
Notes
• A warm battery pack may not be able to be fully
recharged.
• Even when fully charged, battery packs gradually
lose their charge naturally. Use the battery packs as
soon as possible after recharging.
• To prolong the life of battery packs, store them in a
cool place (about 20°C (68°F)), and charge in a place
with an ambient temperature between 10°C and 30°C
(50°F and 86°F).
• At low temperatures, the usable time of battery packs
decreases. The usable time of battery packs increases
if they are warmed to the room temperature (about
20°C (68°F)) before use at low temperatures.
• Carrying a spare battery pack is recommended.
The BP-GL65 and BP-GL95 are free from memory
effect. There is no need to discharge it fully before
recharging.

Camera Adaptor Power Supply

The camera adaptor automatically operates on power
supplied to the CCU/VTR/CMA connector from the
portable VTR, CCU-D50/D50P Camera Control Unit,
AC-550/550CE AC Adaptor or other connected
device.
Note
Before use, check that the device connected to the
CCU/VTR/CMA connector is able to provide the
power required by the camera.
If it is not able to provide the necessary power, or
when it is necessary to prolong the operating time, use
the camera with a separate power supply.
Chapter 2 Fitting and Connections
39