Craftsman C459-36410 Operator's Manual page 13

21” lawn mower
Table of Contents

Advertisement

Adding Fuel
An adult should fuel this engine. NEVER allow children to refuel the engine.
Gasoline (fuel) vapors are highly flammable and can explode. Fuel vapors
can spread and be ignited by a spark or flame many feet away from engine.
To prevent injury or death from fuel fires, follow these instructions:
NOTE: Some engines may not have the fuel cap installed for shipping purposes. To
install, remove and discard the fuel tank dust cap labeled "Discard". Remove the
bubble wrap packaging from around the fuel cap and tighten securely.
DO NOT use leaded fuel.
Fuel must be fresh and clean. NEVER use fuel left over from last
season or stored for long periods.
NEVER mix oil with fuel.
DO NOT use fuel containing Methanol (Wood Alcohol)
NOTE: Before refueling, allow engine to cool two minutes.
1.
Clean around fuel fill before removing cap to fuel.
2.
Fill tank until fuel reaches 1⁄2 inch below the bottom of the filler neck to allow
space for fuel expansion. Be careful not to overfill.
3.
Replace the gasoline cap and tighten securely. Wipe up spilled fuel before
starting engine. If fuel is spilled DO NOT start engine. Move machine away
from area of spillage. Avoid creating any source of ignition until fuel vapors
are gone.
Be sure no one other than the operator is standing near the lawn mower
while starting engine or operating mower. Never run engine indoors or
in enclosed, poorly ventilated areas. Engine exhaust contains carbon
monoxide, an odorless and deadly gas. Keep hands, feet, hair and loose
clothing away from any moving parts on engine and lawn mower.
To Start Engine
1.
Standing behind the mower, squeeze the blade control against upper handle.
2.
Turn ignition key to the right to start the engine. Release the key after the
engine starts. See Figure 15.
3.
Recoil Start:
Pull the starter grip lightly until resistance is felt, then pull rapidly to
overcome compression, prevent kickback and start engine. Repeat if
necessary. Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
Rapid retraction of starter cord (kickback) will pull hand and arm toward
engine faster than you can let go. Broken bones, fractures, bruises or
sprains could result.
To Stop Engine
1.
Release blade control to stop the engine and blade.
Wait for the blade to stop completely before performing any work on the
mower or to remove the grass catcher.
OPERATION
CAUTION
WARNING
WARNING
WARNING
Using Your Lawn Mower
Be sure lawn is clear of stones, sticks, wire, or other objects which could damage
lawn mower or engine. Such objects could be accidently thrown by the mower in
any direction and cause serious personal injury to the operator and others.
The operation of any lawn mower can result in foreign objects being
thrown into the eyes, which can damage your eyes severely. Always
wear safety glasses while operating the mower, or while performing any
adjustments or repairs on it.
2
3
Using as Mulcher
For mulching grass, remove the grass catcher and side discharge chute from the
mower. For effective mulching, do not cut wet grass. If the grass has been allowed
to grow in excess of four inches, mulching is not recommended. Use the grass
catcher to bag clippings instead.
Using Grass Catcher
You can use the grass catcher to collect clippings while you are operating the mower.
1.
Attach grass catcher following instructions in the "Assembly" section. Grass
clippings will automatically collect in bag as you run mower. Operate mower
until grass bag is full.
2.
Stop engine completely by releasing the blade control. Make sure that the
unit has come to a complete stop.
3.
Lift discharge door and pull grass bag up and away from the mower to
remove the bag. Dispose of the grass clippings and reinstall the bag when
complete.
If you strike a foreign object, stop the engine. Disconnect the spark plug
wire, thoroughly inspect mower for any damage, and repair damage
before restarting and operating. Extensive vibration of mower during
operation is an indication of damage. The unit should be promptly
inspected and repaired.
13
WARNING
1
Figure 15
WARNING

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents