Table of Contents
Advertisement
3.3 Motherboard Components
Processor and Heatsink Installation
The processor (CPU) and processor carrier should be assembled together first to form
the processor carrier assembly. This will be attached to the heatsink to form the processor
heatsink module (PHM) before being installed onto the CPU socket.
Notes:
•
Use ESD protection.
•
Unplug the AC power cord from all power supplies after shutting down the system.
•
Check that the plastic protective cover is on the CPU socket and none of the socket pins
are bent. If they are, contact your retailer.
•
When handling the processor, avoid touching or placing direct pressure on the LGA lands
(gold contacts). Improper installation or socket misalignment can cause serious damage
to the processor or CPU socket, which may require manufacturer repairs.
•
Thermal grease is pre-applied on a new heatsink. No additional thermal grease is needed.
•
Refer to the Supermicro website for updates on processor support.
•
All graphics in this manual are for illustration only. Your components may look different.
The Processor
The Intel Xeon 8100/6100/5100/4100/3100 processor series comes in two models: Fabric
(F Model) and Non-Fabric (Non-F Model). Only the Non-Fabric model is supported for this
system.
The Processor Carrier Assembly
The processor carrier assembly is the processor and a plastic carrier.
Processor
Chapter 3: Maintenance and Component Installation
Processor Carrier
29
Advertisement
Table of Contents
