Advertisement
10. Clean contact surfaces of
wheel and wheel hub. Install
spare wheel on wheel hub.
Insert wheel bolts and tighten
them slightly.
To avoid paint damage, place
wheel flat against hub and hold it
there while installing first wheel
bolt.
Unscrew the alignment bolt (1) to
install the last wheel bolt.
11. Lower car. Remove jack and
insert jack tube cover.
Before storing the jack, the jack arm
must be lowered almost to the base of
the jack.
Warning!
Always replace wheel bolts
damaged
or rusted.
Never apply oil or grease
bolts.
Damaged wheel hub
threads
be repaired
immediately.
Incorrect mounting bolts or
improperly tightened mounting bolts
can cause the wheel to come off. This
could cause an accident.
use the correct mounting bolts.
12. Using the wrench, tighten the
five bolts evenly, following the
sequence illustrated, until all
bolts are tight.
Observe a tightening torque of
80 ft.lb. (110 Nm).
13. Ensure proper tire pressure.
Important!
When installing new wheels the
mounting bolts must be retightened
after approx. 60 - 300 miles (100 to
500 km).
that
are
to
wheel
should
Be
sure to
102
Advertisement
