Viking Professional 200 Series Installation Manual page 10

Installation Procedure (cont'd.)
5b
Front Panel Attached
Front Panel Removed
Remove front panel to access the front leveling legs.
5c
Leveling legs will be raised during shipping. Adjust
front leveling legs down by using a 1/4 drive ratchet.
6a Front Panel Attached
When the adjustment nut is visible, complete the
lowering of the legs from the top. When the legs are
down, tighten the locking nut on the top of the leg.
To level center rear leg, see Step 5a.
18
All manuals and user guides at all-guides.com
6
To check level, front to back, pull the top rack half-way
out of unit. The rack should remain stationary and not
move in or out. After unit is level, replace front panel
and ensure overflow channel is in place.
Front Panel Removed
Installation Procedure (cont'd.)
7
Attach screws through trim pieces into cabinets.
(select models).
8
Minimum
20"
(50.8 cm)
from floor
Install High Loop Clip, which is provided, a
minimum of 20" (50.8 cm) from the floor.
10A
(Discharge with food waste disposer)
19
7b
Attach screws through bracket into cabinets
(select models).
9
1.0"
(2.5 cm)
Cut here for 5/8"
(1.6 cm)
Cut here for 3/4"
(1.9 cm)
Identify discharge connection size; cut line to
correct size and connect. Clamp if necessary.
10B
(Standard discharge)