Ip Phone Startup Verification - Cisco 8831NR Administration Manual

Cisco Unified IP Conference Phone Installation
Step 5
Press Cancel to revert to the Wireless Microphones Menu.
Step 6 Press Retry to start the pairing process again.
Related Topics
Unpair Wireless Microphone
If you need to connect a wired microphone to the conference station, any wireless microphones must be
unpaired first. You can also use this procedure to unpair a microphone that is no longer in use.
Note This option is not available if the microphone is connected. To enable the unpair command, place the wireless
microphone in its charger or turn it off.
Procedure
Step 1
Choose Applications > Admin Settings > Wireless Microphones.
Step 2 Select either Wireless Microphone 1 or Wireless Microphone 2.
If the selected channel is paired, the Unpair softkey displays.
Step 3 Press Unpair.
A verification prompt with the options to Cancel or Unpair displays.
Step 4
Press Unpair to continue to unpair the microphone.
The microphone channel's registration information in the base deletes. If you view the microphone channel's
status in phone info menu, the status value and RFID are empty.
Step 5 Press return to revert to the wireless microphones menu and stop the process.
Related Topics

IP Phone Startup Verification

After the conference phone has power connected to it, it begins the startup diagnostic process by cycling
through the following steps.
1. The specified LED buttons flash on and off during the various stages of boot up as the conference phone
checks its hardware. See the following table for a list of the hardware test and the LED diagnostic status.
Table 19: LED Diagnostic Status
Unpair Wireless Microphone, on page 53
Pair Wireless Microphone, on page 52
Hardware Test
Power is Ready
Cisco Unified IP Conference Phone 8831 and 8831NR Administration Guide
Sound Base LEDs
Green LEDs flash
Unpair Wireless Microphone
DCU LEDs
Red and Green LEDs flash
53