Craftsman 486.244411 Operator's Manual page 7

STEP 2: (SEE FIGURE 2)
• Attach the R.H. hanger bracket to the two front empty
holes on the right side of the tractor frame using two
new 3/8" x 1" hex bolts (D), 3/8" lock washers (R),
and 3/8" flat washers (N) as shown. For the rear hole,
use a 3/8" x 1" hex bolt (D), 3/8" lock washer (R)
and 3/8" flat washer (N) with a large 1/2" washer (M)
placed between the hanger bracket and the tractor
frame. Tighten. Repeat for the left side.
INSTRUCTIONS FOR ALL 917 MODEL
• Proceed to
TRACTORS on page 8.
3/8" FLAT
WASHER (N)
3/8" LOCK
WASHER (R)
3/8" x 1"
HEX BOLT (D)
R.H. HANGER
BRACKET
FIGURE 2
1/2" LARGE
WASHER (M)
INSTRUCTIONS FOR TYPE B TRACTORS
STEP 1: (SEE FIGURE 1)
• Remove any bolts found in the holes indicated in the
illustration.
REMOVE BOLTS FROM
THESE HOLES
FIGURE 1
STEP 2: (SEE FIGURE 2)
• Attach the R.H. hanger bracket to the three holes
shown on the side of the tractor frame using three
3/8" x 1" hex bolts (D), 3/8" lock washers (R), 3/8"
flat washers (N) and 1/2" large washers (M). Use 3/8"
nylock nuts (L) on inside of frame if bolts insert freely
into holes. Tighten.
• Repeat for other side.
INSTRUCTIONS FOR ALL 917 MODEL
• Proceed to
TRACTORS on page 8.
NOTE: Use special 3/8" x 1" thread forming bolts (G) in any
holes that are too small for regular bolts.
3/8" x 1" HEX BOLT (D)
(OR THREAD FORMING
BOLT (G) IF NEEDED)
3/8" LOCK
WASHER (R)
3/8" FLAT
WASHER (N)
R.H. HANGER
BRACKET
FIGURE 2
7
FRONT
SUSPENSION
BRACKET
3/8" NYLOCK NUT (L)
(IF NEEDED)
1/2" LARGE
WASHER (M)