Table of Contents
Advertisement
Security functions
SmartCard SystemLock (depending on configuration)
With SystemLock enabled, the device can only be started using an initialised SmartCard (SICRYPT,
CardOS or Fujitsu) and a personal identification number (PIN). The SmartCard and PIN are
checked during system booting in the BIOS, i.e. before the operating system is started.
SmartCard SystemLock
SmartCard SystemLock
Install Single PC:
Install Group PC:
SmartCard
Switchingon the system
All new SmartCards have a preset PIN (Personal Identification Number)
and PUK (Personal Unblocking Key).
On SICRYPT and CardOS SmartCards, the value 12345678 is preset
for the PIN and the PUK.
On Fujitsu cards, the value 0000 is preset for the PIN and the value
administrator is preset for the PUK. For security reasons, we recommend
that you change both PIN and PUK without fail.
Additional software (e.g. Smarty) is required so that the system can also check that
the correct SmartCard is inserted while the system is running.
For information on how to uninstall SystemLock, please refer to "Uninstall SystemLock".
A system which was protected using SystemLock can no longer be released.
Always create a backup copy of the SmartCard which was used.
66
Not Installed
[Enter]
[Enter]
Item Specific Help
Installs the security
for this PC, and
creates a new
SystemLock Admin
SmartCard dedicated to
this PC.
SmartCard data will be
overwritten.
A correct SmartCard is
required for a
permanent installation
Fujitsu
Advertisement
Table of Contents
