Miele KM 360 Installation Instructions Manual
Hide thumbs
Also See for KM 360:
- Operating instructions manual (20 pages) ,
- Installation instructions manual (28 pages)
Related Manuals for Miele KM 360
Summary of Contents for Miele KM 360
- Page 1 Installation Instructions Gas cooktop KM 360 ® ® To prevent accidents and machine damage, read these instructions before installation or use. M.-Nr. 06 390 460...
- Page 2 WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. – Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
-
Page 3: Table Of Contents
Contents IMPORTANT SAFETY INSTRUCTIONS ....... . . 4 Appliance dimensions ..........6 Installation . -
Page 4: Important Safety Instructions
However, under certain circumstances not allowed it may be possible for installation in these applications. Please contact the Miele Technical Service Department with specific requirements. - Page 5 IMPORTANT SAFETY INSTRUCTIONS Safety distances above the The cooktop must not be installed over a dishwasher, washer, dryer, appliance refrigerator or freezer. Heat radiated by the cooktop may damage them. Deep fat fryers must not be installed next to gas cooktops. Gas flames can ignite splattering oil.
-
Page 6: Appliance Dimensions
Appliance dimensions a Built in depth b Electrical connection box c Gas connection R ½" NPT ^ Rember to maintain the minimum safety distances to combustible surfaces: " (70 mm) between the cooktop and the back wall and - 12" (305 mm) between the cooktop and a side wall or tall unit to the right or left of the cooktop. -
Page 7: Installation
Installation Setting the cooktop into place Securing the cooktop ^ Screw the gas regulator onto the nipple underneath the cooktop. For convenience, an AGA or CGA approved flexible stainless steel gas hose (accordion type) may be used between the gas connection and the regulator. -
Page 8: Electrical Connection
Electrical connection This appliance must be electrically This appliance is equipped with a grounded. All electrical work should three-prong grounding plug to be performed by a qualified prevent shock hazards. It should be electrician in accordance with local plugged directly into a properly or national codes and the: grounded outlet. -
Page 9: Gas Connection
Gas connection Installation and service must be The gas connection must be made performed by a qualified installer, in accordance with local codes or in service agency or the gas supplier. the absence of local codes with: In Massachusetts a licensed the National Fuel Gas Code, plumber/gas fitter is required. -
Page 10: Gas Pressure Regulator
- 4" w.c. Do not use any regulator unless it LP gas - 10" w.c. has been supplied by Miele. Doing so may cause a gas leak. If there is any doubt concerning installation contact the Miele Technical... - Page 11 Gas connection Nominal Rating Table NG (Natural gas) LP (Liquid propane gas) Auxiliary burner BTU/hr Max. output 3400 Min. output 0.26 Normal burner Max. output 6000 1.76 Min. output 1200 0.35 Fast burner Max. output 10200 Min. output 1700 All burners Max.
-
Page 12: Converting To Another Type Of Gas
If the appliance is to be connected to a type of gas other than it was originally configured for, both the regulator and burners must be converted. A conversion kit is available as an optional accessory from the Miele Technical Service Department. - Page 16 Alterations rights reserved / 3606 M.-Nr. 06 390 460 / 06 en - USA...