Setup And Connections; Step 1: Unpack The System; Step 2: Connect Your Receiver To Your Tv And Other Devices; Things To Know Before Connecting - RCA DXD416RE User Manual

Setup and Connections

Step 1: Unpack the System

Make sure to locate the remote control and the VCR controller.
Step 2: Connect Your Receiver to
Your TV and Other Devices
During the satellite dish antenna installation, the receiver may have
been connected to your TV with just a coaxial cable for the system test.
Depending on what components you have, another connection may
provide better picture and audio quality. The following sections provide
cable and connection information to help you decide what connection is
best for you.

Things to Know Before Connecting

Components

Protect Your Components from Power Surges
• Connect all components before plugging any power cords into the
wall outlet.
• Always turn off the receiver, TV, and other components before you
connect or disconnect any cables.
Position Cables Correctly to Avoid Audio Hum or
Interference
• Insert all cable plugs firmly into their jacks.
• Place the audio/video cables to the sides of the TV's back panel
instead of straight down the middle after you connect your
components.
• Try not to coil any twin-lead cables; keep them away from the audio/
video cables as much as possible.
• Make sure all antennas and cables are properly grounded. Refer to
the safety sheet packed with your unit.
Protect Your Components from Overheating
• Do not block ventilation holes in any of the components. Arrange
the components so that air can circulate freely.
• Do not stack components.
• Allow adequate ventilation when placing your components in a
stand.
• Place an amplifier or receiver on the top shelf of the stand so that
heated air rising from it will not flow around other components.
2
Remote Control
Receiver
VCR Controller