Table of Contents
Advertisement
Remote Controller
Contents
1.
2. PERSONAL PRESET 1/2/3 buttons: Registers the current setting conditions such
as input selector, listening mode, etc. or call the registered settings. (
3. Input selector buttons: Switches the input to be played.
4. Play buttons: Used for playback operation of a BLUETOOTH-enabled device. If the unit
is switched to "CEC MODE" using the MODE button, an HDMI CEC function-enabled AV
component can be operated. (Depending on the device, operation may not be possible.)
5.
quickly during play on the TV screen. (
6. Cursor buttons and ENTER button: Select the item with the cursors and press
ENTER to confirm your selection.
7.
more enjoyable experience with this unit. (
8. TONE/DIALOG/SW buttons: Adjusts the sound quality of the speakers and
volume level of the subwoofer. (
9. LISTENING MODE buttons: Allows you to select the listening mode. (
10. DIMMER button: You can switch the display off or adjust the brightness of the
display in three steps.
11. CLEAR button: Deletes all characters you have entered when entering text on
the TV screen.
12. +Fav button: Used to register AM/FM radio stations. (
13. SLEEP button: Set the sleep timer. Select the time from "30 min", "60 min" and
"90 min". (
14. ZONE A/B button: Selects an audio output destination from among "ZONE A",
"ZONE B" and "ZONE A+B".(
15.
16.
17.
18. Volume buttons
19. AUDIO SEL button: When a device is connected to two or more audio input
terminals for one input selector, you can select which audio input signal to play.
20. SOUND RETRIEVER button: Turns on/off the Sound Retriever function that
provides better sound quality for compressed audio.
21. MODE button: Switches between automatic tuning and manual tuning for AM/FM stations
(
you can switch "4. Play buttons" between "CEC MODE" and "RCV MODE" (normal mode).
13
Connections
≫
≫
STANDBY/ON button
(AV ADJUST) button: Settings such as "HDMI" and "Audio" can be made
button: Display advanced setting items on the TV or the display to have a
p49)
p51)
p45)
(STATUS) button: Switches the information on the display and is used to operate RDS (
button: Returns the display to the previous state.
button: Temporarily mutes audio. Press again to cancel muting.
p40). Also, when an HDMI CEC function-enabled AV component is connected to this unit,
Front Panel≫ Rear Panel≫ Remote≫
Playback
Setup
≫
p47)
p83)
p69)
p52)
p42)
p44).
≫
Advertisement
Table of Contents
