Table of Contents
Advertisement
Configuration
3.5 Additional Properties
The following table describes the options available under Additional Properties in the navigation tree (see
the settings, click Apply in the lower right corner of the window.
Navigation
Tree Label
NFN
Settings
18
Table 3.3 Additional Properties
Property
Gateway Settings
Mode
Displays the mode in which the PC NFN Gateway is running.
System
Displays the unique system password set up in the workstation.
Password
General Information
Connection
Displays the type of connection port used (USB).
Port
Connection
Describes how the gateway is connected to the NFN.
Type
NCM Version
Displays the NCM version number.
Note: NCM Version does not appear when there is no NFN connection.
NCM Status
Displays the NCM status, which can be: Piezo, UPS Failure, Network Fail Port A,
Bits
Network Fail Port B, High Speed Audio, NCM Sniffer Mode Active, Local Connection
Limit Exceeded, or None.
Note: NCM Status Bits does not appear if when there is no NFN connection.
Fire Network
Displays one of the following depending on the type of time synchronization used:
Time Policy
• Send time: The PC NFN Gateway sets the time on the NFN network.
• Unsynced: The PC NFN Gateway and NFN network are not synchronized with
each other.
Node Settings
Node
Enter the NFN node number of the PC NFN Gateway.
(Default is 240)
Panel Label
Enter panel label.
• Select None for no Mass Notification.
Mass
• Select Higher than Fire for Mass Notification events to take priority over Fire
Notification
events.
Priority
• Select Lower than Fire for Fire events to take priority over Mass Notification
events.
Mass
Displays the priority level configured in the workstation configuration tool (System >
Notification
System Options). Workstation must be running in PPCU mode for this setting to be
Priority
configured.
Network Settings
• Select High for a high-noise NFN network.
Channel A
• Set to Low for a low-noise NFN network.
Threshold
• Select High for a high-noise NFN network.
Channel B
• Set to Low for a low-noise NFN network.
Threshold
• Select Yes for a Class X SLC (Signaling Line Circuit) configured NFN network.
Class X
• Select No for a Class B SLC configured NFN network (default).
• Select Yes to make the PC NFN Gateway send messages to each panel on the
Send Time to
NFN network to synchronize the panel time to that of the PC NFN Gateway.
Panels
• Selecting No prevents time from being sent to panels.
PC NFN Gateway Installation and Operation Manual — P/N LS10077-000NF-E:C5 5/6/2022
Figure
Value
Additional Properties
3.1). After configuring
Advertisement
Table of Contents
