How To Connect: Tv + Satellite Receiver + Vcr - RCA D52130 User Manual

Connections & Setup
VCR
SATELLITE
RECEIVER

How to Connect: TV + Satellite Receiver + VCR

1. Connect your VCR to your TV.
A. Connect a coaxial cable to the VCR's antenna output and to the ANTENNA/CABLE INPUT jack on the TV.
B. Connect the VCR's audio/video output jacks to the INPUT1 AUDIO (R and L) and VIDEO jacks on the TV using
audio/video cables.
2. Make sure cable or antenna is connected to your VCR.
A. Connect the coaxial cable carrying your television signal (off air or cable) to the antenna input on the VCR.
3. Connect your Satellite Receiver to your TV.
A. Connect the satellite receiver's audio/video output jacks to the INPUT2 AUDIO (R and L) and VIDEO jacks on the TV
using audio/video cables. If your satellite receiver has an S-Video output, you can make the video connection by
using the S-Video jacks instead.
Note: If you are using an S-Video cable, you must also use audio cables. The S-Video cable only transfers video
information.
Viewing the Components
1. Turn on the TV and the component(s) you want to view.
2. Press the TV button on the remote control.
3. Press the INPUT button on the remote control to scroll through the video inputs.
• The VCR can be viewed on the VID1 input channel.
• The satellite receiver can be viewed on the VID2 input channel.
Note: You can set up the TV to automatically tune to the correct input channel. This is called Autotuning. (See Chapter
3 for more information.)
10
CABLE
VIDEO L AUDIO R
IN
ANTENNA IN
VIDEO L AUDIO R
OUT
ANTENNA OUT
1B
S-VIDEO
VIDEO L AUDIO
R
OUT
3
OR
OFF-AIR ANTENNA
2
1A
AUDIO
VIDEO L
R S-VIDEO
INPUT1
ANTENNA/
CABLE INPUT
INPUT2
INPUT3
POWER
COMPONENT VIDEO INPUT
AUDIO
Y P P
R B R
HIGH RESOLUTION
INPUT
L
AUDIO INPUTS
L R
HDTV MONITOR
AUDIO OUTPUTS
FIXED
VARIABLE
L R L R
EXT SPEAKERS
G-LINK EXT
INT
+ +
L
R
Go to page 15
Chapter 1