Sony VPL-PX35 Installation Manual page 15

5
Lift and remove the lens.
6
Using a Philips screwdriver, remove the four
screws (M3×6, black) holding the left and right
spacers as shown in the diagram, and then remove
the spacers.
Note
The spacer and the screws may be needed later on.
Store them.
7
Remove the two screws (M3×8, silver) from the
section in the figure, and then remove the lens
bottom cover.
8
Lift up and tilt the left side of the lens bottom
cover, bring it toward the right side, and then
remove it in the right upward direction while
keeping it tilted.
9
Align the positions so that the stopper for the lens
is in contact with the stopper of the projector unit,
and then attach the lens.
Stopper
(Projector)
Stopper
(Lens)
Note
For ease in identification when you install the lens,
make sure that the lens stopper is facing up.
10
Using a Philips screwdriver, tighten the four
screws (M3×10, with washers) that secure the
lens in place.
11
Use the two screws (M3×8, silver) to mount the
removed lens bottom cover over the lens in the
orientation shown in the figure below.
Stopper
(Projector)
Stopper
(Lens)
15