Baby Trend Secure 35 Owner's Manual page 29

11.0 Harness System Use and Adjustment
3. If the Harness Straps require adjustment, remove your child from
the Car Seat. Rotate the handle to the upright carry position.
4. Loosen the Harness Straps by depressing the Harness Adjuster
Button located below the flap just ahead of the Harness Buckle and
pulling on the harness straps.
5. Turn the seat over. Locate the Belt Adjuster Plate near the bottom
of the seat. (Fig 55-1) Remove both Harness Straps from the Belt
Adjuster Plate. From the front of the seat, pull the Harness Straps out
through the harness slots in the seat back and seat pad. (Fig 55-2)
A
B
A
B
55-1
6. Position the Harness Strap over the
Harness Slot selected in step 2 above and
using the included Belt Threading Tool,
push the Harness Straps through the Slots,
in the seat pad and the seat shell, repeat
for the other Shoulder Strap. (Fig 55-3)
7. From the rear of the Car Seat, pull the Harness Straps through the
Slots until you have enough strap to reach the Belt Adjuster Plate.
55
55-2
Belt Threading Tool
55-3
Copyright © 2021, Baby Trend, Inc.
11.0 Harness System Use and Adjustment
8. Reassemble the Harness Straps to the Belt Adjuster Plate. You
have two adjustment positions on the harness. Use Position A for a
smaller child, and Position B for a larger child. Do the left Harness
Strap first, followed by the right Harness Strap. Check that Harness
Straps are completely within the Belt Adjuster Plate loop (Fig 56-1).
If using Position A, loop B must be on top of the Belt Adjuster Plate.
(Fig 56-2)
56-1
9. Inspect the Harness Straps from the front and rear to ensure that
they are not twisted. Twisted straps can prevent proper tightening
of the Harness and thus may not adequately restrain your child in a
sharp turn, sudden stop or crash.
10. Before using the Car Seat, please pull on
the Harness Straps from the front to ensure
that they are securely reattached.
Copyright © 2021, Baby Trend, Inc.
A
A
B
B
56-2
56