Using The Light Off Function; Using The Auto Clean Function - LG LW8022IVSM Owner's Manual

Wi-Fi
5
Enables connection of the air conditioner to
the home Wi-Fi.
NOTE
• Follow instructions on ThinQ application
on how to connect to your unit.
Clean Filter
6
The Clean Filter LED lights up to notify you
that the filter needs to be cleaned. After
cleaning the filter, press Temp
together on the control panel to turn off the
Clean Filter light.
NOTE
• The filter reset must be done using the
control panel, not the remote control.
• This feature is a reminder to clean the
air filter for more efficient operation.
The LED light turns on after 250 hours
of operation.
Fan Speed
7
Press to set the Fan Speed to Low (F1),
Medium (F2) or High (F3).
Temperature Control
8
The thermostat monitors room
temperature to maintain the desired
temperature. The thermostat can be set
between 60 °F–86 °F (16 °C–30 °C).
Press or arrows to increase or
decrease temperature setting.
Energy Saver
9
In this mode the compressor and fan
turn off when the set temperature is
achieved. Approximately every 3 minutes
the fan turns on to allow the unit sensor
to accurately determine if more cooling is
needed.
NOTE
• This function is available with Cooling
Mode.
Clear
10
Cancel Sleep and Timer settings.
NOTE
• Auto Restart : If the air conditioner turns
off due to a power outage, it will restart
automatically once the power is restored, with
the same settings as were set before the unit
turned off.
• Energy Saver : The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
• The remote control will not function properly if
the AC infrared sensor is exposed to direct light
and
or if there are obstacles between the remote
controller and the air conditioner.
Using the Light Off
Function
You can set the brightness of the control panel,
• Press Mode button on the remote control for 3
seconds, or
• Press Mode and Sleep button button together
on the control panel.
NOTE
• Turn on/off the control panel.
Using the Auto Clean
Function
In the Cooling and Dry Mode, Moisture is
generated inside the indoor unit. This function
removes such moisture.
• Press Energy Saver button on the remote
control for 3 seconds.
•
NOTE
• If you turn off the unit, the fan continues to run
for 10 minutes and cleans the inside of the
indoor unit.
is displayed on the remote control.
EN
15