Volvo S60 2021 Owner's Manual page 440

STARTING AND DRIVING
Programming HomeLink
Follow these instructions to program
®
HomeLink , reset all programming, or pro-
gram individual buttons.
NOTE
In some vehicles, the ignition must be on
or in the "accessory position" before
®
HomeLink can be programmed or used. It
can be a good idea to put new batteries in
the remote control being replaced by
®
HomeLink for faster programming and
better radio signal transmission. The
®
HomeLink buttons should be reset before
programming.
WARNING
®
While HomeLink is being programmed,
the garage door or gate being programmed
may be activated. Make sure that no one is
near the door or gate during programming.
When programming a garage door opener,
it is advised to park outside of the garage.
22 Certain markets only.
438
®
22
1. Point the remote control at the
*
HomeLink
hold it about 2-8 cm (1-3 inches) from the
button. Do not obstruct the HomeLink
indicator light.
Note: Some remote controls are more
effective at programming HomeLink
a distance of about 15-20 cm (6-12
inches). Keep this in mind if you experi-
ence any programming difficulties.
2. Press and hold both the remote control
button and the HomeLink
programmed.
®
button to be programmed and
®
®
from
®
button to be
3. Do not release the buttons until the indica-
tor light has stopped flashing slowly
(about once a second) and either flashes
quickly (about 10 times a second) or
glows steadily.
> If the indicator light glows steadily:
Indication that programming is com-
plete. Press the programmed button
twice to activate.
If the indicator light flashes quickly:
The device being programmed with
®
HomeLink may have a security func-
tion that requires an extra step. Try
pressing the programmed button twice
to see whether the programming
works. Otherwise, continue with the
following steps.
* Option/accessory.