Serial Ata (Sata) Interface; Hot-Plug Compatibility; Serial Ata Device Plug Connector Pin Definitions - Seagate ST16000NM008G Product Manual

www.seagate.com
4.0

Serial ATA (SATA) interface

These drives use the industry-standard Serial ATA interface that supports FIS data transfers. It supports ATA
programmed input/output (PIO) modes 0–4; multiword DMA modes 0–2, and Ultra DMA modes 0–6.
For detailed information about the Serial ATA interface, refer to the "Serial ATA: High Speed Serialized AT Attachment"
specification.
4.1

Hot-Plug compatibility

Exos X16 SATA drives incorporate connectors which enable users to hot plug these drives in accordance with the
Serial ATA Revision 3.3 specification. This specification can be downloaded from www.serialata.org.
Caution
:
The drive motor must come to a complete stop (Ready to spindle stop time indicated in
prior to changing the plane of operation. This time is required to insure data integrity.
4.2

Serial ATA device plug connector pin definitions

Table 10 summarizes the signals on the Serial ATA interface and power connectors.
Table 10 Serial ATA connector pin definitions
Segment Pin Function
Signal S1 Ground
S2 A+
S3 A-
S4 Ground
S5 B-
S6 B+
S7 Ground
Key and spacing separate signal and power segments
Power P1 V33
P2 V33
P3 V33
P4 Ground
P5 Ground
P6 Ground
P7 V5
P8 V5
P9 V5
P10 Ground
P11 Ground or LED signal
P12 Ground
P13 V12
P14 V12
P15 V12
Seagate Exos X16 SATA Product Manual, Rev. A
Definition
2nd mate
Differential signal pair A from Phy
2nd mate
Differential signal pair B from Phy
2nd mate
3.3V power
3.3V power
3.3V power, pre-charge, 2nd mate
1st mate
2nd mate
2nd mate
5V power, pre-charge, 2nd mate
5V power
5V power
2nd mate
If grounded, drive does not use deferred spin
1st mate.
12V power, pre-charge, 2nd mate
12V power
12V power
Serial ATA (SATA) interface
Section 2.4)
27