Advertisement
6. TROUBLESHOOTING
a) When the reader is first powered on it will beep 4-times,
and the LED will shine red.
b) Presenting a supported access credential will result in the
reader beeping and the LED flashing once.
c) Mobile operation is optimized for smartphones supporting
BLE (Bluetooth LE) version 4.2 or newer. Further, for the
downloading of mobile access credentials, a stable, high-
quality internet connection is recommended.
Note:
The access panel controls LED functionality, such as switching
the LED to green. If the reader does not recognize the mobile
credential, card, tag (no beep, no LED flash) or exhibits short
read range, see table below for possible causes and solutions.
Possible Cause
Incorrect cabling
Not enough power
Incorrect credential used
Reader/access panel not
properly grounded
Supply generating
interference
Should any of the corrective actions mentioned above not
improve performance, disconnect the reader from the access
panel and power it with a separate power supply or 9 VDC
battery, and re-test card functionality.
By powering the readers separately, most variables that may
lead to reduced performance can be eliminated. Should the
problem persist, please contact Camden directly.
Opening New Doors to
Innovation, Quality and Support!
Corrective Action
Verify gauge, connections
and cabling length
12 VDC recommended
Verify if credential technology
is supported
Earth ground needed—verify
shield and reader ground are tied
at access panel and connect
to ground at one point
Linear power supply
recommended, verify
switching power supply
before use
Call: 1.877.226.3369 / 905.366.3377
Visit: www.camdencontrols.com
CV-7600 SERIES - BLE BLUETOOTH CARD READER
FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Caution:
Changes or modifications not expressly approved by Camden
Door could void the user's authority to operate the equipment.
Product can be used without license conditions or restrictions
in all European Union countries, including Austria, Belgium,
Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland,
France, Germany, Greece, Hungary, Ireland, Italy, Latvia,
Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal,
Romania, Slovakia, Spain, Sweden, Unite Kingdom as well
as other non-EU countries, including Iceland, Norway and
Switzerland.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device. Camden Controls
reserves the right to change specifications without notice.
Cet appareil est conforme à Industrie Canada exempts de
licence standard RSS (s). Le fonctionnement est soumis
aux deux conditions suivantes : (1) ce dispositif ne peut pas
provoquer d'interférences et (2) ce dispositif doit accepter toute
interférence, y compris les interférences qui peuvent causer un
mauvais fonctionnement du dispositif.
Note:
This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in
a residential area is likely to cause harmful interference
in which case the user will be required to correct the
interference at his own expense.
IN S TALL AT ION INSTRUCTIO NS
File: CV-7600-BLE_Manual_v2.indd
Rev.: 06/08 -/2020
Part No: 40-82B244
Page 5 of 5
Advertisement
