Wireless Remote Control - LG LW6019ER Owner's Manual

14
OPERATION
Temperature Control
5
The thermostat monitors room temperature
to maintain the desired temperature. The
thermostat can be set between 60 °F–86 °F
(16 °C–30 °C). Press
increase or decrease temperature setting.
Remote Control Sensor
6
Clean Filter
7
The Clean Filter LED lights up to notify you
together on the control panel to turn off the
Clean Filter light.
NOTE
control panel, not the remote control.
● This feature is a reminder to clean the air
light turns on after 250 hours of operation.
Energy Saver
8
In this mode the compressor and fan turn
off when the set temperature is achieved.
Approximately every 3 minutes the fan turns
on to allow the unit sensor to accurately
determine if more cooling is needed.
NOTE
● This function is available with Cooling
Mode.
Timer Clear
9
Cancel Timer setting.
NOTE
● Auto Restart: If the air conditioner turns off due
to a power outage, it will restart automatically
once the power is restored, with the same
settings as were set before the unit turned off.
● Energy Saver: The unit defaults to the Energy
Saver mode each time the unit is switched on
except in Fan mode or when power is restored
after an electrical power outage.
● The remote control will not function properly if
the AC infrared sensor is exposed to direct light
or if there are obstacles between the remote
controller and the air conditioner.

Wireless Remote Control

Inserting Battery
or arrows to
If the display screen of the remote control begins
to fade, replace the batteries. Insert AAA (1.5 V)
batteries before using the remote control.
1
Temp
and
2
NOTE
● New batteries are supplied with the air
conditioner for use in the remote control.
● Do not use a rechargeable battery. Make sure
that the battery is new.
● In order to prevent discharge, remove the
battery from the remote control if the air
conditioner is not going to be used for an
extended period of time.
● Keep the remote control away from extremely
hot or humid places.
● To maintain optimal operation of the remote
control, the remote sensor should not be
exposed to direct sunlight.
Remove the cover on the back of the
remote control.
Insert the new batteries and make sure that
the + and - terminals of the batteries are
installed correctly.