Table of Contents
Advertisement
Quick guide
●
Repeat rate
The refresh rate determines how often a DiSEqC
command is output. A refresh is only necessary with
cascaded system.
●
Control voltage
The control voltage controls the switch of the
polarisation level (horizontal/vertical) in non-DiSEqC
capable components (e.g., control of single LNBs
via DiSEqC multiswitch).
●
22kHz signal
The 22kHz signal controls the switching between
high and low band in the Band setting. The Position
setting controls the selection of the satellites in non-
DiSEqC capable components.
●
Toneburst
The Toneburst controls the selection of the satellites
in non-DiSEqC but Toneburst capable components
with the Position and Option settings.
Press OK to adopt settings and press
1 Select Satellite1 to Satellite4.
2 Select satellite name from list and press OK. Press
to continue.
J
3 Specify here the oscillator frequency for your LNB.
Normally you do not need to change the values
for high and low band, unless the LNB of your
satellite system uses a different oscillator frequency
(important for the frequency display).
See Setting options for all DVB-S reception on
page 13 to continue.
12
Setting options for DiSEqC one cable
communal system
1 Select which DiSEqC single cable system you are
2 Select satellite name from list and press OK. Press
to continue.
J
3 Specify here the oscillator frequency for your LNB
4 Select and adjust settings for DiSEqC single cable
Continue with Setting options for all types of
reception on page 13.
using and press OK.
to continue.
J
and press OK. Press
J
Normally you do not need to change the values
for high and low band, unless the LNB of your
satellite system uses a different oscillator frequency
(important for the frequency display).
communal installation.
Select the desired transmission channel and the
corresponding transmission frequency.
PIN protection
If your system is designed for it, it is possible to
protect your used transmission data from use by
other subscribers with a PIN.
Define/change PIN
Here you can determine and change the PIN for
PIN protection. Only possible when yes has been
selected for PIN protection.
to continue.
Advertisement
Table of Contents
Troubleshooting
